mac80211: extend/document powersave API
This modifies hardware flags for powersave to support three different
flags:
* IEEE80211_HW_SUPPORTS_PS - indicates general PS support
* IEEE80211_HW_PS_NULLFUNC_STACK - indicates nullfunc sending in software
* IEEE80211_HW_SUPPORTS_DYNAMIC_PS - indicates dynamic PS on the device
It also adds documentation for all this which explains how to set the
various flags.
Additionally, it fixes a few things:
* a spot where && was used to test flags
* enable CONF_PS only when associated again
Signed-off-by: Johannes Berg <johannes@sipsolutions.net>
Signed-off-by: John W. Linville <linville@tuxdriver.com>
diff --git a/drivers/net/wireless/rt2x00/rt61pci.c b/drivers/net/wireless/rt2x00/rt61pci.c
index 82d35a5..549480a 100644
--- a/drivers/net/wireless/rt2x00/rt61pci.c
+++ b/drivers/net/wireless/rt2x00/rt61pci.c
@@ -2556,7 +2556,9 @@
*/
rt2x00dev->hw->flags =
IEEE80211_HW_HOST_BROADCAST_PS_BUFFERING |
- IEEE80211_HW_SIGNAL_DBM;
+ IEEE80211_HW_SIGNAL_DBM |
+ IEEE80211_HW_SUPPORTS_PS |
+ IEEE80211_HW_PS_NULLFUNC_STACK;
rt2x00dev->hw->extra_tx_headroom = 0;
SET_IEEE80211_DEV(rt2x00dev->hw, rt2x00dev->dev);