mfd: Fix missing stmpe kerneldoc
Generating kerneldoc for STMPE result in warnings, so fix this by
adding missing documentation.
Signed-off-by: Om Prakash <omprakash.pal@stericsson.com>
Reviewed-by: Rabin Vincent <rabin.vincent@stericsson.com>
Reviewed-by: Jonas Aberg <jonas.aberg@stericsson.com>
Reviewed-by: Srinidhi Kasagar <srinidhi.kasagar@stericsson.com>
Signed-off-by: Linus Walleij <linus.walleij@linaro.org>
Signed-off-by: Samuel Ortiz <sameo@linux.intel.com>
diff --git a/drivers/mfd/stmpe.c b/drivers/mfd/stmpe.c
index 7ab7746..2963689c 100644
--- a/drivers/mfd/stmpe.c
+++ b/drivers/mfd/stmpe.c
@@ -228,7 +228,7 @@
EXPORT_SYMBOL_GPL(stmpe_block_write);
/**
- * stmpe_set_altfunc: set the alternate function for STMPE pins
+ * stmpe_set_altfunc()- set the alternate function for STMPE pins
* @stmpe: Device to configure
* @pins: Bitmask of pins to affect
* @block: block to enable alternate functions for
diff --git a/drivers/mfd/stmpe.h b/drivers/mfd/stmpe.h
index 0dbdc4e..e4ee3895 100644
--- a/drivers/mfd/stmpe.h
+++ b/drivers/mfd/stmpe.h
@@ -42,6 +42,7 @@
* @id_mask: bits valid in CHIPID register for comparison with id_val
* @num_gpios: number of GPIOS
* @af_bits: number of bits used to specify the alternate function
+ * @regs: variant specific registers.
* @blocks: list of blocks present on this device
* @num_blocks: number of blocks present on this device
* @num_irqs: number of internal IRQs available on this device
diff --git a/include/linux/mfd/stmpe.h b/include/linux/mfd/stmpe.h
index e762c27..be1af7c 100644
--- a/include/linux/mfd/stmpe.h
+++ b/include/linux/mfd/stmpe.h
@@ -57,6 +57,7 @@
* @irq_lock: IRQ bus lock
* @dev: device, mostly for dev_dbg()
* @i2c: i2c client
+ * @partnum: part number
* @variant: the detected STMPE model number
* @regs: list of addresses of registers which are at different addresses on
* different variants. Indexed by one of STMPE_IDX_*.
@@ -121,6 +122,8 @@
* @norequest_mask: bitmask specifying which GPIOs should _not_ be
* requestable due to different usage (e.g. touch, keypad)
* STMPE_GPIO_NOREQ_* macros can be used here.
+ * @setup: board specific setup callback.
+ * @remove: board specific remove callback
*/
struct stmpe_gpio_platform_data {
int gpio_base;