ath6kl: Request P2P capabilities during target init
Signed-off-by: Jouni Malinen <jouni@qca.qualcomm.com>
Signed-off-by: Kalle Valo <kvalo@qca.qualcomm.com>
diff --git a/drivers/net/wireless/ath/ath6kl/init.c b/drivers/net/wireless/ath/ath6kl/init.c
index ad9716c..48c82e9 100644
--- a/drivers/net/wireless/ath/ath6kl/init.c
+++ b/drivers/net/wireless/ath/ath6kl/init.c
@@ -417,6 +417,7 @@
static int ath6kl_target_config_wlan_params(struct ath6kl *ar)
{
int status = 0;
+ int ret;
/*
* Configure the device for rx dot11 header rules. "0,0" are the
@@ -461,6 +462,15 @@
status = -EIO;
}
+ ret = ath6kl_wmi_info_req_cmd(ar->wmi, P2P_FLAG_CAPABILITIES_REQ |
+ P2P_FLAG_MACADDR_REQ |
+ P2P_FLAG_HMODEL_REQ);
+ if (ret) {
+ ath6kl_dbg(ATH6KL_DBG_TRC, "failed to request P2P "
+ "capabilities (%d) - assuming P2P not supported\n",
+ ret);
+ }
+
return status;
}