skge: XM PHY handling fixes
Change how PHY is managed on SysKonnect fibre based boards.
Poll for PHY coming up 1 per second, but use interrupt to detect loss.
Signed-off-by: Stephen Hemminger <shemminger@linux-foundation.org>
Signed-off-by: Jeff Garzik <jeff@garzik.org>
diff --git a/drivers/net/skge.c b/drivers/net/skge.c
index d5c10fd..180e82f 100644
--- a/drivers/net/skge.c
+++ b/drivers/net/skge.c
@@ -57,7 +57,7 @@
#define TX_WATCHDOG (5 * HZ)
#define NAPI_WEIGHT 64
#define BLINK_MS 250
-#define LINK_HZ (HZ/2)
+#define LINK_HZ HZ
MODULE_DESCRIPTION("SysKonnect Gigabit Ethernet driver");
MODULE_AUTHOR("Stephen Hemminger <shemminger@linux-foundation.org>");
@@ -995,19 +995,15 @@
{
struct net_device *dev = hw->dev[port];
struct skge_port *skge = netdev_priv(dev);
- u16 cmd, msk;
+ u16 cmd = xm_read16(hw, port, XM_MMU_CMD);
- if (hw->phy_type == SK_PHY_XMAC) {
- msk = xm_read16(hw, port, XM_IMSK);
- msk |= XM_IS_INP_ASS | XM_IS_LIPA_RC | XM_IS_RX_PAGE | XM_IS_AND;
- xm_write16(hw, port, XM_IMSK, msk);
- }
+ xm_write16(hw, port, XM_IMSK, XM_IMSK_DISABLE);
- cmd = xm_read16(hw, port, XM_MMU_CMD);
cmd &= ~(XM_MMU_ENA_RX | XM_MMU_ENA_TX);
xm_write16(hw, port, XM_MMU_CMD, cmd);
+
/* dummy read to ensure writing */
- (void) xm_read16(hw, port, XM_MMU_CMD);
+ xm_read16(hw, port, XM_MMU_CMD);
if (netif_carrier_ok(dev))
skge_link_down(skge);
@@ -1103,7 +1099,7 @@
/* reset the statistics module */
xm_write32(hw, port, XM_GP_PORT, XM_GP_RES_STAT);
- xm_write16(hw, port, XM_IMSK, 0xffff); /* disable XMAC IRQs */
+ xm_write16(hw, port, XM_IMSK, XM_IMSK_DISABLE);
xm_write32(hw, port, XM_MODE, 0); /* clear Mode Reg */
xm_write16(hw, port, XM_TX_CMD, 0); /* reset TX CMD Reg */
xm_write16(hw, port, XM_RX_CMD, 0); /* reset RX CMD Reg */
@@ -1141,7 +1137,7 @@
u16 status;
/* read twice because of latch */
- (void) xm_phy_read(hw, port, PHY_BCOM_STAT);
+ xm_phy_read(hw, port, PHY_BCOM_STAT);
status = xm_phy_read(hw, port, PHY_BCOM_STAT);
if ((status & PHY_ST_LSYNC) == 0) {
@@ -1342,7 +1338,7 @@
mod_timer(&skge->link_timer, jiffies + LINK_HZ);
}
-static void xm_check_link(struct net_device *dev)
+static int xm_check_link(struct net_device *dev)
{
struct skge_port *skge = netdev_priv(dev);
struct skge_hw *hw = skge->hw;
@@ -1350,25 +1346,25 @@
u16 status;
/* read twice because of latch */
- (void) xm_phy_read(hw, port, PHY_XMAC_STAT);
+ xm_phy_read(hw, port, PHY_XMAC_STAT);
status = xm_phy_read(hw, port, PHY_XMAC_STAT);
if ((status & PHY_ST_LSYNC) == 0) {
xm_link_down(hw, port);
- return;
+ return 0;
}
if (skge->autoneg == AUTONEG_ENABLE) {
u16 lpa, res;
if (!(status & PHY_ST_AN_OVER))
- return;
+ return 0;
lpa = xm_phy_read(hw, port, PHY_XMAC_AUNE_LP);
if (lpa & PHY_B_AN_RF) {
printk(KERN_NOTICE PFX "%s: remote fault\n",
dev->name);
- return;
+ return 0;
}
res = xm_phy_read(hw, port, PHY_XMAC_RES_ABI);
@@ -1384,7 +1380,7 @@
default:
printk(KERN_NOTICE PFX "%s: duplex mismatch\n",
dev->name);
- return;
+ return 0;
}
/* We are using IEEE 802.3z/D5.0 Table 37-4 */
@@ -1408,11 +1404,14 @@
if (!netif_carrier_ok(dev))
genesis_link_up(skge);
+ return 1;
}
/* Poll to check for link coming up.
+ *
* Since internal PHY is wired to a level triggered pin, can't
- * get an interrupt when carrier is detected.
+ * get an interrupt when carrier is detected, need to poll for
+ * link coming up.
*/
static void xm_link_timer(unsigned long arg)
{
@@ -1420,29 +1419,35 @@
struct net_device *dev = skge->netdev;
struct skge_hw *hw = skge->hw;
int port = skge->port;
+ int i;
+ unsigned long flags;
if (!netif_running(dev))
return;
- if (netif_carrier_ok(dev)) {
- xm_read16(hw, port, XM_ISRC);
- if (!(xm_read16(hw, port, XM_ISRC) & XM_IS_INP_ASS))
- goto nochange;
- } else {
- if (xm_read32(hw, port, XM_GP_PORT) & XM_GP_INP_ASS)
- goto nochange;
- xm_read16(hw, port, XM_ISRC);
- if (xm_read16(hw, port, XM_ISRC) & XM_IS_INP_ASS)
- goto nochange;
+ spin_lock_irqsave(&hw->phy_lock, flags);
+
+ /*
+ * Verify that the link by checking GPIO register three times.
+ * This pin has the signal from the link_sync pin connected to it.
+ */
+ for (i = 0; i < 3; i++) {
+ if (xm_read16(hw, port, XM_GP_PORT) & XM_GP_INP_ASS)
+ goto link_down;
}
- spin_lock(&hw->phy_lock);
- xm_check_link(dev);
- spin_unlock(&hw->phy_lock);
-
-nochange:
- if (netif_running(dev))
- mod_timer(&skge->link_timer, jiffies + LINK_HZ);
+ /* Re-enable interrupt to detect link down */
+ if (xm_check_link(dev)) {
+ u16 msk = xm_read16(hw, port, XM_IMSK);
+ msk &= ~XM_IS_INP_ASS;
+ xm_write16(hw, port, XM_IMSK, msk);
+ xm_read16(hw, port, XM_ISRC);
+ } else {
+link_down:
+ mod_timer(&skge->link_timer,
+ round_jiffies(jiffies + LINK_HZ));
+ }
+ spin_unlock_irqrestore(&hw->phy_lock, flags);
}
static void genesis_mac_init(struct skge_hw *hw, int port)
@@ -1686,14 +1691,16 @@
printk(KERN_DEBUG PFX "%s: mac interrupt status 0x%x\n",
skge->netdev->name, status);
- if (hw->phy_type == SK_PHY_XMAC &&
- (status & (XM_IS_INP_ASS | XM_IS_LIPA_RC)))
- xm_link_down(hw, port);
+ if (hw->phy_type == SK_PHY_XMAC && (status & XM_IS_INP_ASS)) {
+ xm_link_down(hw, port);
+ mod_timer(&skge->link_timer, jiffies + 1);
+ }
if (status & XM_IS_TXF_UR) {
xm_write32(hw, port, XM_MODE, XM_MD_FTF);
++skge->net_stats.tx_fifo_errors;
}
+
if (status & XM_IS_RXF_OV) {
xm_write32(hw, port, XM_MODE, XM_MD_FRF);
++skge->net_stats.rx_fifo_errors;
@@ -1753,11 +1760,12 @@
}
xm_write32(hw, port, XM_MODE, mode);
- msk = XM_DEF_MSK;
- if (hw->phy_type != SK_PHY_XMAC)
- msk |= XM_IS_INP_ASS; /* disable GP0 interrupt bit */
+ /* Turn on detection of Tx underrun, Rx overrun */
+ msk = xm_read16(hw, port, XM_IMSK);
+ msk &= ~(XM_IS_RXF_OV | XM_IS_TXF_UR);
xm_write16(hw, port, XM_IMSK, msk);
+
xm_read16(hw, port, XM_ISRC);
/* get MMU Command Reg. */