[SCSI] fusion - fix pci express bug
The fix is to write 'MPI_HIM_DIM' to the Host Interrupt Mask
register, when enabling interrupts. Instead of the
tilde of MPI_HIM_RIM.
Apparently writing '1's to some of the reserved bits was causing
all the bits to go to `1`, which effectly disabled all interrupts.
Signed-off-by: Eric Moore <Eric.Moore@lsil.com>
Signed-off-by: James Bottomley <James.Bottomley@SteelEye.com>
diff --git a/drivers/message/fusion/mptbase.c b/drivers/message/fusion/mptbase.c
index 3321337..d890b2b 100644
--- a/drivers/message/fusion/mptbase.c
+++ b/drivers/message/fusion/mptbase.c
@@ -1630,7 +1630,7 @@
pci_enable_device(pdev);
/* enable interrupts */
- CHIPREG_WRITE32(&ioc->chip->IntMask, ~(MPI_HIM_RIM));
+ CHIPREG_WRITE32(&ioc->chip->IntMask, MPI_HIM_DIM);
ioc->active = 1;
/* F/W not running */
@@ -1723,7 +1723,7 @@
/* (re)Enable alt-IOC! (reply interrupt, FreeQ) */
dprintk((KERN_INFO MYNAM ": alt-%s reply irq re-enabled\n",
ioc->alt_ioc->name));
- CHIPREG_WRITE32(&ioc->alt_ioc->chip->IntMask, ~(MPI_HIM_RIM));
+ CHIPREG_WRITE32(&ioc->alt_ioc->chip->IntMask, MPI_HIM_DIM);
ioc->alt_ioc->active = 1;
}
@@ -1839,7 +1839,7 @@
if (ret == 0) {
/* Enable! (reply interrupt) */
- CHIPREG_WRITE32(&ioc->chip->IntMask, ~(MPI_HIM_RIM));
+ CHIPREG_WRITE32(&ioc->chip->IntMask, MPI_HIM_DIM);
ioc->active = 1;
}
@@ -1847,7 +1847,7 @@
/* (re)Enable alt-IOC! (reply interrupt) */
dinitprintk((KERN_INFO MYNAM ": alt-%s reply irq re-enabled\n",
ioc->alt_ioc->name));
- CHIPREG_WRITE32(&ioc->alt_ioc->chip->IntMask, ~(MPI_HIM_RIM));
+ CHIPREG_WRITE32(&ioc->alt_ioc->chip->IntMask, MPI_HIM_DIM);
ioc->alt_ioc->active = 1;
}