| * Qualcomm WCNSS Platform Driver |
| |
| WCNSS driver is the platform driver. It is used for performing the cold |
| boot-up of the wireless device. It is responsible for adjusting |
| the necessary I/O rails and enabling appropriate gpios for wireless |
| connectivity subsystem. |
| |
| Required properties: |
| - compatible: "wcnss_wlan" |
| - reg: physical address and length of the register set for the device. |
| - reg-names: "wcnss_mmio", "wcnss_fiq" |
| - interupts: Pronto to Apps interrupts for tx done and rx pending. |
| - qcom,pronto-vddmx-supply: regulator to supply pronto pll. |
| - qcom,pronto-vddcx-supply: regulator to supply WLAN/BT/FM digital module. |
| - qcom,pronto-vddpx-supply: regulator to supply WLAN DAC. |
| - qcom,iris-vddxo-supply : regulator to supply RF XO. |
| - qcom,iris-vddrfa-supply : regulator to supply RFA digital. |
| - qcom,iris-vddpa-supply : regulator to supply RF PA. |
| - qcom,iris-vdddig-supply : regulator to supply RF digital(BT/FM). |
| - gpios: gpio numbers to configure 5-wire interface of WLAN connectivity |
| - qcom,has_48mhz_xo: boolean flag to determine the usage of 24MHz XO from RF |
| - qcom,has_pronto_hw: boolean flag to determine the revId of the WLAN subsystem |
| |
| Example: |
| |
| qcom,wcnss-wlan@fb000000 { |
| compatible = "qcom,wcnss_wlan"; |
| reg = <0xfb000000 0x280000>, |
| <0xf9011008 0x04>; |
| reg-names = "wcnss_mmio", "wcnss_fiq"; |
| interrupts = <0 145 0 0 146 0>; |
| interrupt-names = "wcnss_wlantx_irq", "wcnss_wlanrx_irq"; |
| |
| qcom,pronto-vddmx-supply = <&pm8841_s1>; |
| qcom,pronto-vddcx-supply = <&pm8841_s2>; |
| qcom,pronto-vddpx-supply = <&pm8941_s3>; |
| qcom,iris-vddxo-supply = <&pm8941_l6>; |
| qcom,iris-vddrfa-supply = <&pm8941_l11>; |
| qcom,iris-vddpa-supply = <&pm8941_l19>; |
| qcom,iris-vdddig-supply = <&pm8941_l3>; |
| |
| gpios = <&msmgpio 36 0>, <&msmgpio 37 0>, <&msmgpio 38 0>, |
| <&msmgpio 39 0>, <&msmgpio 40 0>; |
| qcom,has_48mhz_xo; |
| qcom,has_pronto_hw; |
| }; |