rt2x00: Don't enable broad- and multicast buffering on USB devices
Since rt2x00 USB devices have no chance to know when a beacon was sent
out in AP mode currently all broad- and multicast traffic is buffered in
mac80211 but never sent out at all.
Unfortunately we have no chance in sending the traffic out after a
DTIM beacon due to hw limitations. Hence, instead of never sending the
buffered traffic out better send it out immediately.
Signed-off-by: Helmut Schaa <helmut.schaa@googlemail.com>
Reported-by: Lauri Hintsala <lauri.hintsala@bluegiga.com>
Signed-off-by: Ivo van Doorn <IvDoorn@gmail.com>
Signed-off-by: John W. Linville <linville@tuxdriver.com>
diff --git a/drivers/net/wireless/rt2x00/rt2500usb.c b/drivers/net/wireless/rt2x00/rt2500usb.c
index 5843a6d..1033964 100644
--- a/drivers/net/wireless/rt2x00/rt2500usb.c
+++ b/drivers/net/wireless/rt2x00/rt2500usb.c
@@ -1674,10 +1674,15 @@
/*
* Initialize all hw fields.
+ *
+ * Don't set IEEE80211_HW_HOST_BROADCAST_PS_BUFFERING unless we are
+ * capable of sending the buffered frames out after the DTIM
+ * transmission using rt2x00lib_beacondone. This will send out
+ * multicast and broadcast traffic immediately instead of buffering it
+ * infinitly and thus dropping it after some time.
*/
rt2x00dev->hw->flags =
IEEE80211_HW_RX_INCLUDES_FCS |
- IEEE80211_HW_HOST_BROADCAST_PS_BUFFERING |
IEEE80211_HW_SIGNAL_DBM |
IEEE80211_HW_SUPPORTS_PS |
IEEE80211_HW_PS_NULLFUNC_STACK;