mv643xx_eth: fix unicast address filter corruption on mtu change
When mv643xx_eth_open() is called to up an interface, port_start()
will first re-program the unicast address filter, and then
re-initialise the PORT_CONFIG register, but that will disable unicast
promiscuous mode if it was enabled by the unicast address filter setup.
This isn't a problem on ifconfig up, as ->set_rx_mode() will be called
shortly afterwards which will program the filters again, but it does
trigger when changing the MTU, which calls mv643xx_eth_stop() and then
mv643xx_eth_open() by hand to repopulate the receive rings with skbuffs
of the new size.
Swap the initialisation of the PORT_START register and the call to
the unicast filter setup function to fix this.
Signed-off-by: Lennert Buytenhek <buytenh@marvell.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/net/mv643xx_eth.c b/drivers/net/mv643xx_eth.c
index 13f11f4..b0bc3bc 100644
--- a/drivers/net/mv643xx_eth.c
+++ b/drivers/net/mv643xx_eth.c
@@ -2030,11 +2030,6 @@
}
/*
- * Add configured unicast address to address filter table.
- */
- mv643xx_eth_program_unicast_filter(mp->dev);
-
- /*
* Receive all unmatched unicast, TCP, UDP, BPDU and broadcast
* frames to RX queue #0, and include the pseudo-header when
* calculating receive checksums.
@@ -2047,6 +2042,11 @@
wrlp(mp, PORT_CONFIG_EXT, 0x00000000);
/*
+ * Add configured unicast addresses to address filter table.
+ */
+ mv643xx_eth_program_unicast_filter(mp->dev);
+
+ /*
* Enable the receive queues.
*/
for (i = 0; i < mp->rxq_count; i++) {