[POWERPC] mpc5200: Add generic support for simple MPC5200 based boards
This patch adds support for 'mpc5200-simple-platform' compatible
boards which do not need a platform specific setup. Such boards
are supported assuming the following:
- GPIO pins are configured by the firmware,
- CDM configuration (clocking) is setup correctly by firmware,
- if the 'fsl,has-wdt' property is present in one of the
gpt nodes, then it is safe to use such gpt to reset the board,
- PCI is supported if enabled in the kernel configuration
and if there is a PCI bus node defined in the device tree.
Signed-off-by: Marian Balakowicz <m8@semihalf.com>
Signed-off-by: Grant Likely <grant.likely@secretlab.ca>
diff --git a/arch/powerpc/platforms/52xx/Makefile b/arch/powerpc/platforms/52xx/Makefile
index 307dbc1..fe1b81b 100644
--- a/arch/powerpc/platforms/52xx/Makefile
+++ b/arch/powerpc/platforms/52xx/Makefile
@@ -6,6 +6,7 @@
obj-$(CONFIG_PCI) += mpc52xx_pci.o
endif
+obj-$(CONFIG_PPC_MPC5200_SIMPLE) += mpc5200_simple.o
obj-$(CONFIG_PPC_EFIKA) += efika.o
obj-$(CONFIG_PPC_LITE5200) += lite5200.o