mm: Use aligned zone start for pfn_to_bitidx calculation
The current calculation in pfn_to_bitidx assumes that
(pfn - zone->zone_start_pfn) >> pageblock_order will return the
same bit for all pfn in a pageblock. If zone_start_pfn is not
aligned to pageblock_nr_pages, this may not always be correct.
Consider the following with pageblock order = 10, zone start 2MB:
pfn | pfn - zone start | (pfn - zone start) >> page block order
----------------------------------------------------------------
0x26000 | 0x25e00 | 0x97
0x26100 | 0x25f00 | 0x97
0x26200 | 0x26000 | 0x98
0x26300 | 0x26100 | 0x98
This means that calling {get,set}_pageblock_migratetype on a single
page will not set the migratetype for the full block. Fix this by
rounding down zone_start_pfn when doing the bitidx calculation.
Change-Id: I13e2f53f50db294f38ec86138c17c6fe29f0ee82
Signed-off-by: Laura Abbott <lauraa@codeaurora.org>
diff --git a/mm/page_alloc.c b/mm/page_alloc.c
index 92dd060..b6a2510 100644
--- a/mm/page_alloc.c
+++ b/mm/page_alloc.c
@@ -5422,7 +5422,7 @@
pfn &= (PAGES_PER_SECTION-1);
return (pfn >> pageblock_order) * NR_PAGEBLOCK_BITS;
#else
- pfn = pfn - zone->zone_start_pfn;
+ pfn = pfn - round_down(zone->zone_start_pfn, pageblock_nr_pages);
return (pfn >> pageblock_order) * NR_PAGEBLOCK_BITS;
#endif /* CONFIG_SPARSEMEM */
}