Input: twl6040-vibra: Check the selected path for vibra
The VIBSELL/R bit in the VIBCTLL/R register tells the source of the data,
which is going to be used to drive the attached motor(s).
Do not allow effect execution if any of the channels are set to receive
audio data.
Signed-off-by: Peter Ujfalusi <peter.ujfalusi@ti.com>
Acked-by: Dmitry Torokhov <dtor@mail.ru>
Signed-off-by: Mark Brown <broonie@opensource.wolfsonmicro.com>
diff --git a/drivers/input/misc/twl6040-vibra.c b/drivers/input/misc/twl6040-vibra.c
index cb74185..2a828e5 100644
--- a/drivers/input/misc/twl6040-vibra.c
+++ b/drivers/input/misc/twl6040-vibra.c
@@ -201,6 +201,13 @@
struct vibra_info *info = input_get_drvdata(input);
int ret;
+ /* Do not allow effect, while the routing is set to use audio */
+ ret = twl6040_get_vibralr_status(info->twl6040);
+ if (ret & TWL6040_VIBSEL) {
+ dev_info(&input->dev, "Vibra is configured for audio\n");
+ return -EBUSY;
+ }
+
info->weak_speed = effect->u.rumble.weak_magnitude;
info->strong_speed = effect->u.rumble.strong_magnitude;
info->direction = effect->direction < EFFECT_DIR_180_DEG ? 1 : -1;