usb: EHCI, OHCI: Add configuration for the SH USB controller

The SH EHCI/OHCI driver hardcoded the CPU type in {ehci,ohci}-hcd.c.
So if we will add the new CPU, we had to add to the hcd driver each time.
The patch adds the CONFIG_USB_{EHCI,OHCI}_SH configuration. So if we
want to use the SH EHCI/OHCI, we only enable the configuration.

Signed-off-by: Yoshihiro Shimoda <yoshihiro.shimoda.uh@renesas.com>
Signed-off-by: Greg Kroah-Hartman <gregkh@suse.de>
diff --git a/drivers/usb/host/Kconfig b/drivers/usb/host/Kconfig
index 923e5a0..9116d30 100644
--- a/drivers/usb/host/Kconfig
+++ b/drivers/usb/host/Kconfig
@@ -173,6 +173,13 @@
 	  Enables support for the USB controller present on the PowerPC
 	  OpenFirmware platform bus.
 
+config USB_EHCI_SH
+	bool "EHCI support for SuperH USB controller"
+	depends on USB_EHCI_HCD && SUPERH
+	---help---
+	  Enables support for the on-chip EHCI controller on the SuperH.
+	  If you use the PCI EHCI controller, this option is not necessary.
+
 config USB_W90X900_EHCI
 	bool "W90X900(W90P910) EHCI support"
 	depends on USB_EHCI_HCD && ARCH_W90X900
@@ -326,6 +333,13 @@
 
 	  If unsure, say N.
 
+config USB_OHCI_SH
+	bool "OHCI support for SuperH USB controller"
+	depends on USB_OHCI_HCD && SUPERH
+	---help---
+	  Enables support for the on-chip OHCI controller on the SuperH.
+	  If you use the PCI OHCI controller, this option is not necessary.
+
 config USB_CNS3XXX_OHCI
 	bool "Cavium CNS3XXX OHCI Module"
 	depends on USB_OHCI_HCD && ARCH_CNS3XXX