| #ifndef HOSTAP_CONFIG_H |
| #define HOSTAP_CONFIG_H |
| |
| #define PRISM2_VERSION "0.4.4-kernel" |
| |
| /* In the previous versions of Host AP driver, support for user space version |
| * of IEEE 802.11 management (hostapd) used to be disabled in the default |
| * configuration. From now on, support for hostapd is always included and it is |
| * possible to disable kernel driver version of IEEE 802.11 management with a |
| * separate define, PRISM2_NO_KERNEL_IEEE80211_MGMT. */ |
| /* #define PRISM2_NO_KERNEL_IEEE80211_MGMT */ |
| |
| /* Maximum number of events handler per one interrupt */ |
| #define PRISM2_MAX_INTERRUPT_EVENTS 20 |
| |
| /* Include code for downloading firmware images into volatile RAM. */ |
| #define PRISM2_DOWNLOAD_SUPPORT |
| |
| /* Allow kernel configuration to enable download support. */ |
| #if !defined(PRISM2_DOWNLOAD_SUPPORT) && defined(CONFIG_HOSTAP_FIRMWARE) |
| #define PRISM2_DOWNLOAD_SUPPORT |
| #endif |
| |
| #ifdef PRISM2_DOWNLOAD_SUPPORT |
| /* Allow writing firmware images into flash, i.e., to non-volatile storage. |
| * Before you enable this option, you should make absolutely sure that you are |
| * using prism2_srec utility that comes with THIS version of the driver! |
| * In addition, please note that it is possible to kill your card with |
| * non-volatile download if you are using incorrect image. This feature has not |
| * been fully tested, so please be careful with it. */ |
| /* #define PRISM2_NON_VOLATILE_DOWNLOAD */ |
| #endif /* PRISM2_DOWNLOAD_SUPPORT */ |
| |
| /* Save low-level I/O for debugging. This should not be enabled in normal use. |
| */ |
| /* #define PRISM2_IO_DEBUG */ |
| |
| /* Following defines can be used to remove unneeded parts of the driver, e.g., |
| * to limit the size of the kernel module. Definitions can be added here in |
| * hostap_config.h or they can be added to make command with EXTRA_CFLAGS, |
| * e.g., |
| * 'make pccard EXTRA_CFLAGS="-DPRISM2_NO_DEBUG -DPRISM2_NO_PROCFS_DEBUG"' |
| */ |
| |
| /* Do not include debug messages into the driver */ |
| /* #define PRISM2_NO_DEBUG */ |
| |
| /* Do not include /proc/net/prism2/wlan#/{registers,debug} */ |
| /* #define PRISM2_NO_PROCFS_DEBUG */ |
| |
| /* Do not include station functionality (i.e., allow only Master (Host AP) mode |
| */ |
| /* #define PRISM2_NO_STATION_MODES */ |
| |
| #endif /* HOSTAP_CONFIG_H */ |