[SCSI] stex: extend hard reset wait time
During hard bus reset of st_shasta controllers, 1 ms is not enough for
16-port controllers, although it's good for 8-port controllers. Extend the
wait time to 100 ms to allow bus resets finish successfully.
Signed-off-by: Ed Lin <ed.lin@promise.com>
Signed-off-by: James Bottomley <James.Bottomley@SteelEye.com>
diff --git a/drivers/scsi/stex.c b/drivers/scsi/stex.c
index 96dcbac..81dd3b7 100644
--- a/drivers/scsi/stex.c
+++ b/drivers/scsi/stex.c
@@ -1041,7 +1041,12 @@
pci_read_config_byte(bus->self, PCI_BRIDGE_CONTROL, &pci_bctl);
pci_bctl |= PCI_BRIDGE_CTL_BUS_RESET;
pci_write_config_byte(bus->self, PCI_BRIDGE_CONTROL, pci_bctl);
- msleep(1);
+
+ /*
+ * 1 ms may be enough for 8-port controllers. But 16-port controllers
+ * require more time to finish bus reset. Use 100 ms here for safety
+ */
+ msleep(100);
pci_bctl &= ~PCI_BRIDGE_CTL_BUS_RESET;
pci_write_config_byte(bus->self, PCI_BRIDGE_CONTROL, pci_bctl);