ath5k: fix typos, bad comment formatting and GHz in place of MHz
Signed-off-by: Pavel Roskin <proski@gnu.org>
Signed-off-by: John W. Linville <linville@tuxdriver.com>
diff --git a/drivers/net/wireless/ath/ath5k/pcu.c b/drivers/net/wireless/ath/ath5k/pcu.c
index aecd724..618ee54 100644
--- a/drivers/net/wireless/ath/ath5k/pcu.c
+++ b/drivers/net/wireless/ath/ath5k/pcu.c
@@ -32,7 +32,7 @@
#include "base.h"
/*
- * AR5212+ can use higher rates for ack transmition
+ * AR5212+ can use higher rates for ack transmission
* based on current tx rate instead of the base rate.
* It does this to better utilize channel usage.
* This is a mapping between G rates (that cover both
@@ -643,14 +643,14 @@
/* Flush any pending BMISS interrupts on ISR by
* performing a clear-on-write operation on PISR
* register for the BMISS bit (writing a bit on
- * ISR togles a reset for that bit and leaves
- * the rest bits intact) */
+ * ISR toggles a reset for that bit and leaves
+ * the remaining bits intact) */
if (ah->ah_version == AR5K_AR5210)
ath5k_hw_reg_write(ah, AR5K_ISR_BMISS, AR5K_ISR);
else
ath5k_hw_reg_write(ah, AR5K_ISR_BMISS, AR5K_PISR);
- /* TODO: Set enchanced sleep registers on AR5212
+ /* TODO: Set enhanced sleep registers on AR5212
* based on vif->bss_conf params, until then
* disable power save reporting.*/
AR5K_REG_DISABLE_BITS(ah, AR5K_STA_ID1, AR5K_STA_ID1_PWR_SV);
@@ -738,7 +738,7 @@
dma = ath5k_hw_reg_read(ah, AR5K_TIMER1) >> 3;
/* NOTE: SWBA is different. Having a wrong window there does not
- * stop us from sending data and this condition is catched thru
+ * stop us from sending data and this condition is caught by
* other means (SWBA interrupt) */
if (ath5k_check_timer_win(nbtt, atim, 1, intval) &&
@@ -896,7 +896,7 @@
/* Set RSSI/BRSSI thresholds
*
* Note: If we decide to set this value
- * dynamicaly, have in mind that when AR5K_RSSI_THR
+ * dynamically, have in mind that when AR5K_RSSI_THR
* register is read it might return 0x40 if we haven't
* wrote anything to it plus BMISS RSSI threshold is zeroed.
* So doing a save/restore procedure here isn't the right