ASoC: tlv320dac33: Burst mode BCLK divider configuration
Add possibility to configure the burst mode BCLK divider through platform
data structure.
The BCLK divider changes the actual speed of the serial bus in burst mode,
which is faster than the sampling frequency of the running stream.
In this way platforms can experiment with the optimal burst speed without
the need to modify the codec driver itself.
Signed-off-by: Peter Ujfalusi <peter.ujfalusi@nokia.com>
Acked-by: Liam Girdwood <lrg@slimlogic.co.uk>
Signed-off-by: Mark Brown <broonie@opensource.wolfsonmicro.com>
diff --git a/sound/soc/codecs/tlv320dac33.c b/sound/soc/codecs/tlv320dac33.c
index e1aa66f..1b35d0c 100644
--- a/sound/soc/codecs/tlv320dac33.c
+++ b/sound/soc/codecs/tlv320dac33.c
@@ -91,6 +91,7 @@
* this */
enum dac33_fifo_modes fifo_mode;/* FIFO mode selection */
unsigned int nsample; /* burst read amount from host */
+ u8 burst_bclkdiv; /* BCLK divider value in burst mode */
enum dac33_state state;
};
@@ -845,9 +846,18 @@
dac33_write(codec, DAC33_SER_AUDIOIF_CTRL_A, aictrl_a);
dac33_write(codec, DAC33_SER_AUDIOIF_CTRL_B, aictrl_b);
- /* BCLK divide ratio */
+ /*
+ * BCLK divide ratio
+ * 0: 1.5
+ * 1: 1
+ * 2: 2
+ * ...
+ * 254: 254
+ * 255: 255
+ */
if (dac33->fifo_mode)
- dac33_write(codec, DAC33_SER_AUDIOIF_CTRL_C, 3);
+ dac33_write(codec, DAC33_SER_AUDIOIF_CTRL_C,
+ dac33->burst_bclkdiv);
else
dac33_write(codec, DAC33_SER_AUDIOIF_CTRL_C, 32);
@@ -1239,6 +1249,7 @@
i2c_set_clientdata(client, dac33);
dac33->power_gpio = pdata->power_gpio;
+ dac33->burst_bclkdiv = pdata->burst_bclkdiv;
dac33->irq = client->irq;
dac33->nsample = NSAMPLE_MAX;
/* Disable FIFO use by default */