ARM: mach-shmobile: Initial AG5 and AG5EVM support
This patch adds initial support for Renesas SH-Mobile AG5.
At this point the AG5 CPU support is limited to the ARM
core, SCIF serial and a CMT timer together with L2 cache
and the GIC. The AG5EVM board also supports Ethernet.
Future patches will add support for GPIO, INTCS, CPGA
and platform data / driver updates for devices such as
IIC, LCDC, FSI, KEYSC, CEU and SDHI among others.
The code in entry-macro.S will be cleaned up when the
ARM IRQ demux code improvements have been merged.
Depends on the AG5EVM mach-type recently registered but
not yet present in arch/arm/tools/mach-types.
As the AG5EVM board comes with 512MiB memory it is
recommended to turn on HIGHMEM.
Many thanks to Yoshii-san for initial bring up.
Signed-off-by: Magnus Damm <damm@opensource.se>
Signed-off-by: Paul Mundt <lethal@linux-sh.org>
diff --git a/arch/arm/mach-shmobile/board-ag5evm.c b/arch/arm/mach-shmobile/board-ag5evm.c
new file mode 100644
index 0000000..bade04a
--- /dev/null
+++ b/arch/arm/mach-shmobile/board-ag5evm.c
@@ -0,0 +1,159 @@
+/*
+ * arch/arm/mach-shmobile/board-ag5evm.c
+ *
+ * Copyright (C) 2010 Takashi Yoshii <yoshii.takashi.zj@renesas.com>
+ * Copyright (C) 2009 Yoshihiro Shimoda <shimoda.yoshihiro@renesas.com>
+ *
+ * This program is free software; you can redistribute it and/or modify
+ * it under the terms of the GNU General Public License as published by
+ * the Free Software Foundation; version 2 of the License.
+ *
+ * This program is distributed in the hope that it will be useful,
+ * but WITHOUT ANY WARRANTY; without even the implied warranty of
+ * MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE. See the
+ * GNU General Public License for more details.
+ *
+ * You should have received a copy of the GNU General Public License
+ * along with this program; if not, write to the Free Software
+ * Foundation, Inc., 51 Franklin St, Fifth Floor, Boston, MA 02110-1301 USA
+ *
+ */
+
+#include <linux/kernel.h>
+#include <linux/init.h>
+#include <linux/interrupt.h>
+#include <linux/irq.h>
+#include <linux/platform_device.h>
+#include <linux/delay.h>
+#include <linux/io.h>
+#include <linux/dma-mapping.h>
+#include <linux/serial_sci.h>
+#include <linux/smsc911x.h>
+#include <linux/gpio.h>
+#include <mach/hardware.h>
+#include <mach/sh73a0.h>
+#include <mach/common.h>
+#include <asm/mach-types.h>
+#include <asm/mach/arch.h>
+#include <asm/mach/map.h>
+#include <asm/mach/time.h>
+#include <asm/hardware/gic.h>
+#include <asm/hardware/cache-l2x0.h>
+#include <asm/traps.h>
+
+static struct resource smsc9220_resources[] = {
+ [0] = {
+ .start = 0x14000000,
+ .end = 0x14000000 + SZ_64K - 1,
+ .flags = IORESOURCE_MEM,
+ },
+ [1] = {
+ .start = gic_spi(33), /* PINT1 */
+ .flags = IORESOURCE_IRQ,
+ },
+};
+
+static struct smsc911x_platform_config smsc9220_platdata = {
+ .flags = SMSC911X_USE_32BIT | SMSC911X_SAVE_MAC_ADDRESS,
+ .phy_interface = PHY_INTERFACE_MODE_MII,
+ .irq_polarity = SMSC911X_IRQ_POLARITY_ACTIVE_LOW,
+ .irq_type = SMSC911X_IRQ_TYPE_PUSH_PULL,
+};
+
+static struct platform_device eth_device = {
+ .name = "smsc911x",
+ .id = 0,
+ .dev = {
+ .platform_data = &smsc9220_platdata,
+ },
+ .resource = smsc9220_resources,
+ .num_resources = ARRAY_SIZE(smsc9220_resources),
+};
+
+static struct platform_device *ag5evm_devices[] __initdata = {
+ ð_device,
+};
+
+static struct map_desc ag5evm_io_desc[] __initdata = {
+ /* create a 1:1 entity map for 0xe6xxxxxx
+ * used by CPGA, INTC and PFC.
+ */
+ {
+ .virtual = 0xe6000000,
+ .pfn = __phys_to_pfn(0xe6000000),
+ .length = 256 << 20,
+ .type = MT_DEVICE_NONSHARED
+ },
+};
+
+static void __init ag5evm_map_io(void)
+{
+ iotable_init(ag5evm_io_desc, ARRAY_SIZE(ag5evm_io_desc));
+
+ /* setup early devices and console here as well */
+ sh73a0_add_early_devices();
+ shmobile_setup_console();
+}
+
+#define PINTC_ADDR 0xe6900000
+#define PINTER0A (PINTC_ADDR + 0xa0)
+#define PINTCR0A (PINTC_ADDR + 0xb0)
+
+void __init ag5evm_init_irq(void)
+{
+ /* setup PINT: enable PINTA2 as active low */
+ __raw_writel(__raw_readl(PINTER0A) | (1<<29), PINTER0A);
+ __raw_writew(__raw_readw(PINTCR0A) | (2<<10), PINTCR0A);
+
+ gic_dist_init(0, __io(0xf0001000), 29);
+ gic_cpu_init(0, __io(0xf0000100));
+}
+
+#define PORT144CR 0xe6052090
+#define PORT145CR 0xe6052091
+
+#define PORT154CR 0xe605209a
+#define PORT155CR 0xe605209b
+#define PORT156CR 0xe605209c
+#define PORT157CR 0xe605209d
+
+#define PORTR159_128DR 0xe6056004
+
+static void __init ag5evm_init(void)
+{
+ /* enable SCIFA2 */
+ __raw_writeb(0x12, PORT154CR); /* TXD */
+ __raw_writeb(0x22, PORT155CR); /* RXD */
+ __raw_writeb(0x12, PORT156CR); /* RTS */
+ __raw_writeb(0x22, PORT157CR); /* CTS */
+
+ /* enable SMSC911X */
+ __raw_writeb(0x20, PORT144CR); /* PINTA2 */
+ __raw_writeb(0x10, PORT145CR); /* RESET */
+ __raw_writel(__raw_readl(PORTR159_128DR) & ~(1 << 17), PORTR159_128DR);
+
+#ifdef CONFIG_CACHE_L2X0
+ /* Shared attribute override enable, 64K*8way */
+ l2x0_init(__io(0xf0100000), 0x00460000, 0xc2000fff);
+#endif
+ sh73a0_add_standard_devices();
+ platform_add_devices(ag5evm_devices, ARRAY_SIZE(ag5evm_devices));
+}
+
+static void __init ag5evm_timer_init(void)
+{
+ sh73a0_clock_init();
+ shmobile_timer.init();
+ return;
+}
+
+struct sys_timer ag5evm_timer = {
+ .init = ag5evm_timer_init,
+};
+
+MACHINE_START(AG5EVM, "ag5evm")
+ .map_io = ag5evm_map_io,
+ .init_irq = ag5evm_init_irq,
+ .init_machine = ag5evm_init,
+ .timer = &ag5evm_timer,
+MACHINE_END