e1000e: reset MAC-PHY interconnect on 82577/82578 during Sx->S0
During Sx->S0 transitions, the interconnect between the MAC and PHY on
82577/82578 can remain in SMBus mode instead of transitioning to the
PCIe-like mode required during normal operation. Toggling the LANPHYPC
Value bit essentially resets the interconnect forcing it to the correct
mode.
Signed-off-by: Bruce Allan <bruce.w.allan@intel.com>
Signed-off-by: Jeff Kirsher <jeffrey.t.kirsher@intel.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/net/e1000e/ich8lan.c b/drivers/net/e1000e/ich8lan.c
index 5059c22..0bfef8e 100644
--- a/drivers/net/e1000e/ich8lan.c
+++ b/drivers/net/e1000e/ich8lan.c
@@ -83,6 +83,8 @@
#define E1000_ICH_FWSM_RSPCIPHY 0x00000040 /* Reset PHY on PCI Reset */
+/* FW established a valid mode */
+#define E1000_ICH_FWSM_FW_VALID 0x00008000
#define E1000_ICH_MNG_IAMT_MODE 0x2
@@ -259,6 +261,7 @@
static s32 e1000_init_phy_params_pchlan(struct e1000_hw *hw)
{
struct e1000_phy_info *phy = &hw->phy;
+ u32 ctrl;
s32 ret_val = 0;
phy->addr = 1;
@@ -274,6 +277,23 @@
phy->ops.power_down = e1000_power_down_phy_copper_ich8lan;
phy->autoneg_mask = AUTONEG_ADVERTISE_SPEED_DEFAULT;
+ if (!(er32(FWSM) & E1000_ICH_FWSM_FW_VALID)) {
+ /*
+ * The MAC-PHY interconnect may still be in SMBus mode
+ * after Sx->S0. Toggle the LANPHYPC Value bit to force
+ * the interconnect to PCIe mode, but only if there is no
+ * firmware present otherwise firmware will have done it.
+ */
+ ctrl = er32(CTRL);
+ ctrl |= E1000_CTRL_LANPHYPC_OVERRIDE;
+ ctrl &= ~E1000_CTRL_LANPHYPC_VALUE;
+ ew32(CTRL, ctrl);
+ udelay(10);
+ ctrl &= ~E1000_CTRL_LANPHYPC_OVERRIDE;
+ ew32(CTRL, ctrl);
+ msleep(50);
+ }
+
phy->id = e1000_phy_unknown;
ret_val = e1000e_get_phy_id(hw);
if (ret_val)