[MIPS] Alchemy: Remove code wrapped by dead symbol CONFIG_AU1XXX_PSC_SPI
Noticed by Robert P. J. Day (rpjday@mindspring.com).
Signed-off-by: Ralf Baechle <ralf@linux-mips.org>
diff --git a/arch/mips/au1000/pb1200/board_setup.c b/arch/mips/au1000/pb1200/board_setup.c
index 043302b..eea2092 100644
--- a/arch/mips/au1000/pb1200/board_setup.c
+++ b/arch/mips/au1000/pb1200/board_setup.c
@@ -131,14 +131,7 @@
/* The Pb1200 development board uses external MUX for PSC0 to
support SMB/SPI. bcsr->resets bit 12: 0=SMB 1=SPI
*/
-#if defined(CONFIG_AU1XXX_PSC_SPI) && defined(CONFIG_I2C_AU1550)
- #error I2C and SPI are mutually exclusive. Both are physically connected to PSC0.\
- Refer to Pb1200/Db1200 documentation.
-#elif defined( CONFIG_AU1XXX_PSC_SPI )
- bcsr->resets |= BCSR_RESETS_PCS0MUX;
- /*Hard Coding Value to enable Temp Sensors [bit 14] Value for SOC Au1200. Pls refer documentation*/
- bcsr->resets =0x900f;
-#elif defined( CONFIG_I2C_AU1550 )
+#ifdef CONFIG_I2C_AU1550
bcsr->resets &= (~BCSR_RESETS_PCS0MUX);
#endif
au_sync();