ide: always call ->init_chipset method in do_ide_setup_pci_device()
Call ->init_chipset method also for 'tried_config' / '!pciirq' conditions.
Signed-off-by: Bartlomiej Zolnierkiewicz <bzolnier@gmail.com>
diff --git a/drivers/ide/setup-pci.c b/drivers/ide/setup-pci.c
index b15cad5..a95d510 100644
--- a/drivers/ide/setup-pci.c
+++ b/drivers/ide/setup-pci.c
@@ -499,20 +499,21 @@
*/
pciirq = dev->irq;
+ /*
+ * This allows offboard ide-pci cards the enable a BIOS,
+ * verify interrupt settings of split-mirror pci-config
+ * space, place chipset into init-mode, and/or preserve
+ * an interrupt if the card is not native ide support.
+ */
+ ret = d->init_chipset ? d->init_chipset(dev, d->name) : 0;
+ if (ret < 0)
+ goto out;
+
/* Is it an "IDE storage" device in non-PCI mode? */
if ((dev->class >> 8) == PCI_CLASS_STORAGE_IDE && (dev->class & 5) != 5) {
if (noisy)
printk(KERN_INFO "%s: not 100%% native mode: "
"will probe irqs later\n", d->name);
- /*
- * This allows offboard ide-pci cards the enable a BIOS,
- * verify interrupt settings of split-mirror pci-config
- * space, place chipset into init-mode, and/or preserve
- * an interrupt if the card is not native ide support.
- */
- ret = d->init_chipset ? d->init_chipset(dev, d->name) : 0;
- if (ret < 0)
- goto out;
pciirq = ret;
} else if (tried_config) {
if (noisy)
@@ -524,11 +525,6 @@
d->name, pciirq);
pciirq = 0;
} else {
- if (d->init_chipset) {
- ret = d->init_chipset(dev, d->name);
- if (ret < 0)
- goto out;
- }
if (noisy)
printk(KERN_INFO "%s: 100%% native mode on irq %d\n",
d->name, pciirq);