OMAP2+: powerdomain: move header file from plat-omap to mach-omap2
The OMAP powerdomain code and data is all OMAP2+-specific. This seems
unlikely to change any time soon. Move plat-omap/include/plat/powerdomain.h
to mach-omap2/powerdomain.h. The primary point of doing this is to remove
the temptation for unrelated upper-layer code to access powerdomain code
and data directly.
As part of this process, remove the references to powerdomain data
from the GPIO "driver" and the OMAP PM no-op layer, both in plat-omap.
Change the DSPBridge code to point to the new location for the
powerdomain headers. The DSPBridge code should not be including the
powerdomain headers; these should be removed.
Signed-off-by: Paul Walmsley <paul@pwsan.com>
Cc: Kevin Hilman <khilman@deeprootsystems.com>
Cc: Omar Ramirez Luna <omar.ramirez@ti.com>
Cc: Felipe Contreras <felipe.contreras@gmail.com>
Cc: Greg Kroah-Hartman <greg@kroah.com>
diff --git a/arch/arm/plat-omap/include/plat/gpio.h b/arch/arm/plat-omap/include/plat/gpio.h
index 41ff2f8..d6f9fa0 100644
--- a/arch/arm/plat-omap/include/plat/gpio.h
+++ b/arch/arm/plat-omap/include/plat/gpio.h
@@ -82,7 +82,7 @@
/* TODO: Analyze removing gpio_bank_count usage from driver code */
extern int gpio_bank_count;
-extern void omap2_gpio_prepare_for_idle(int power_state);
+extern void omap2_gpio_prepare_for_idle(int off_mode);
extern void omap2_gpio_resume_after_idle(void);
extern void omap_set_gpio_debounce(int gpio, int enable);
extern void omap_set_gpio_debounce_time(int gpio, int enable);