bnx2: Fix the behavior of ethtool when ONBOOT=no
I found a little bug.
When configure in ifcfg-eth* is ONBOOT=no,
the behavior of ethtool command is wrong.
# grep ONBOOT /etc/sysconfig/network-scripts/ifcfg-eth2
ONBOOT=no
# ethtool eth2 | tail -n1
Link detected: yes
I think "Link detected" should be "no".
Signed-off-by: Ooiwa Naohiro <nooiwa@miraclelinux.com>
Acked-by: Michael Chan <mchan@broadcom.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/net/bnx2.c b/drivers/net/bnx2.c
index 38f1c33..b70cc99 100644
--- a/drivers/net/bnx2.c
+++ b/drivers/net/bnx2.c
@@ -6825,6 +6825,14 @@
return 0;
}
+static u32
+bnx2_get_link(struct net_device *dev)
+{
+ struct bnx2 *bp = netdev_priv(dev);
+
+ return bp->link_up;
+}
+
static int
bnx2_get_eeprom_len(struct net_device *dev)
{
@@ -7392,7 +7400,7 @@
.get_wol = bnx2_get_wol,
.set_wol = bnx2_set_wol,
.nway_reset = bnx2_nway_reset,
- .get_link = ethtool_op_get_link,
+ .get_link = bnx2_get_link,
.get_eeprom_len = bnx2_get_eeprom_len,
.get_eeprom = bnx2_get_eeprom,
.set_eeprom = bnx2_set_eeprom,