[IPSEC]: Set skb->data to payload in x->mode->output
This patch changes the calling convention so that on entry from
x->mode->output and before entry into x->type->output skb->data
will point to the payload instead of the IP header.
This is essentially a redistribution of skb_push/skb_pull calls
with the aim of minimising them on the common path of tunnel +
ESP.
It'll also let us use the same calling convention between IPv4
and IPv6 with the next patch.
Signed-off-by: Herbert Xu <herbert@gondor.apana.org.au>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/net/ipv6/xfrm6_tunnel.c b/net/ipv6/xfrm6_tunnel.c
index aeb0607..00a1a3e 100644
--- a/net/ipv6/xfrm6_tunnel.c
+++ b/net/ipv6/xfrm6_tunnel.c
@@ -244,6 +244,7 @@
{
struct ipv6hdr *top_iph;
+ skb_push(skb, -skb_network_offset(skb));
top_iph = ipv6_hdr(skb);
top_iph->payload_len = htons(skb->len - sizeof(struct ipv6hdr));