[SCSI] qla2xxx: Correct needless clean-up resets during shutdown.
There's no point in hitting the RISC with what will most
assuredly be an unsucessful reset of the RISC hardware if the
initial stop-firmware mailbox command fails with a time-out
status. Instead, to avoid what could amount to a lengthy
stop-firmware/detect-failure/reset-risc loop, continue with
driver unloading and discard the stop-firmware requirement.
Signed-off-by: Andrew Vasquez <andrew.vasquez@qlogic.com>
Signed-off-by: James Bottomley <James.Bottomley@HansenPartnership.com>
diff --git a/drivers/scsi/qla2xxx/qla_init.c b/drivers/scsi/qla2xxx/qla_init.c
index d5c7853..4897663 100644
--- a/drivers/scsi/qla2xxx/qla_init.c
+++ b/drivers/scsi/qla2xxx/qla_init.c
@@ -4022,7 +4022,8 @@
return;
ret = qla2x00_stop_firmware(ha);
- for (retries = 5; ret != QLA_SUCCESS && retries ; retries--) {
+ for (retries = 5; ret != QLA_SUCCESS && ret != QLA_FUNCTION_TIMEOUT &&
+ retries ; retries--) {
qla2x00_reset_chip(ha);
if (qla2x00_chip_diag(ha) != QLA_SUCCESS)
continue;