wimax: allow WIMAX_RF_QUERY calls when state is still uninitialized
Until now, calls to wimax_rfkill() will be blocked until the device is
at least past the WIMAX_ST_UNINITIALIZED state, return -ENOMEDIUM when
the device is in the WIMAX_ST_DOWN state.
In parallel, wimax-tools would issue a wimax_rfkill(WIMAX_RF_QUERY)
call right after opening a handle with wimaxll_open() as means to
verify if the interface is really a WiMAX interface [newer kernel
version will have a call specifically for this].
The combination of these two facts is that in some cases, before the
driver has finalized initializing its device's firmware, a
wimaxll_open() call would fail, when it should not.
Thus, change the wimax_rfkill() code to allow queries when the device
is in WIMAX_ST_UNINITIALIZED state.
Signed-off-by: Inaky Perez-Gonzalez <inaky@linux.intel.com>
diff --git a/net/wimax/op-rfkill.c b/net/wimax/op-rfkill.c
index 40e1210..94d339c 100644
--- a/net/wimax/op-rfkill.c
+++ b/net/wimax/op-rfkill.c
@@ -305,8 +305,15 @@
d_fnstart(3, dev, "(wimax_dev %p state %u)\n", wimax_dev, state);
mutex_lock(&wimax_dev->mutex);
result = wimax_dev_is_ready(wimax_dev);
- if (result < 0)
+ if (result < 0) {
+ /* While initializing, < 1.4.3 wimax-tools versions use
+ * this call to check if the device is a valid WiMAX
+ * device; so we allow it to proceed always,
+ * considering the radios are all off. */
+ if (result == -ENOMEDIUM && state == WIMAX_RF_QUERY)
+ result = WIMAX_RF_OFF << 1 | WIMAX_RF_OFF;
goto error_not_ready;
+ }
switch (state) {
case WIMAX_RF_ON:
case WIMAX_RF_OFF: