ath9k_hw: Cleanup Tx calibrations for AR9003 chips
Currently Tx IQ calibration is enabled by default for all AR9003
chips. But for AR9480, the calibration status should be read from
chip after processing ini. And also the carrier leak calibration
status is checked during init cal. As the init_cal is being called
for fast channel change too, the tx_cl status only be read after
full reset. Hence moving that into process ini function.
Signed-off-by: Rajkumar Manoharan <rmanohar@qca.qualcomm.com>
Signed-off-by: John W. Linville <linville@tuxdriver.com>
diff --git a/drivers/net/wireless/ath/ath9k/ar9003_phy.h b/drivers/net/wireless/ath/ath9k/ar9003_phy.h
index c6ed51f..ef90ab7 100644
--- a/drivers/net/wireless/ath/ath9k/ar9003_phy.h
+++ b/drivers/net/wireless/ath/ath9k/ar9003_phy.h
@@ -826,6 +826,7 @@
#define AR_PHY_SPECTRAL_SCAN_SHORT_REPEAT_S 24
#define AR_PHY_CHANNEL_STATUS_RX_CLEAR 0x00000004
#define AR_PHY_TX_IQCAL_CONTROL_0_ENABLE_TXIQ_CAL 0x80000000
+#define AR_PHY_TX_IQCAL_CONTROL_0_ENABLE_TXIQ_CAL_S 31
#define AR_PHY_TX_IQCAL_CONTROL_1_IQCORR_I_Q_COFF_DELPT 0x01fc0000
#define AR_PHY_TX_IQCAL_CONTROL_1_IQCORR_I_Q_COFF_DELPT_S 18
#define AR_PHY_TX_IQCAL_START_DO_CAL 0x00000001