sfc: SFT9001: Fix speed reporting in 1G PHY loopback
Instead of disabling AN in loopback, just prevent restarting AN and
override the speed in sft9001_get_settings().
Signed-off-by: Ben Hutchings <bhutchings@solarflare.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/net/sfc/tenxpress.c b/drivers/net/sfc/tenxpress.c
index 80c8d6e..bc2833f 100644
--- a/drivers/net/sfc/tenxpress.c
+++ b/drivers/net/sfc/tenxpress.c
@@ -511,7 +511,7 @@
{
struct tenxpress_phy_data *phy_data = efx->phy_data;
struct ethtool_cmd ecmd;
- bool phy_mode_change, loop_reset, loop_toggle, loopback;
+ bool phy_mode_change, loop_reset;
if (efx->phy_mode & (PHY_MODE_OFF | PHY_MODE_SPECIAL)) {
phy_data->phy_mode = efx->phy_mode;
@@ -522,12 +522,10 @@
phy_mode_change = (efx->phy_mode == PHY_MODE_NORMAL &&
phy_data->phy_mode != PHY_MODE_NORMAL);
- loopback = LOOPBACK_MASK(efx) & efx->phy_op->loopbacks;
- loop_toggle = LOOPBACK_CHANGED(phy_data, efx, efx->phy_op->loopbacks);
loop_reset = (LOOPBACK_OUT_OF(phy_data, efx, efx->phy_op->loopbacks) ||
LOOPBACK_CHANGED(phy_data, efx, 1 << LOOPBACK_GPHY));
- if (loop_reset || loop_toggle || loopback || phy_mode_change) {
+ if (loop_reset || phy_mode_change) {
int rc;
efx->phy_op->get_settings(efx, &ecmd);
@@ -542,20 +540,6 @@
falcon_reset_xaui(efx);
}
- if (efx->phy_type != PHY_TYPE_SFX7101) {
- /* Only change autoneg once, on coming out or
- * going into loopback */
- if (loop_toggle)
- ecmd.autoneg = !loopback;
- if (loopback) {
- ecmd.duplex = DUPLEX_FULL;
- if (efx->loopback_mode == LOOPBACK_GPHY)
- ecmd.speed = SPEED_1000;
- else
- ecmd.speed = SPEED_10000;
- }
- }
-
rc = efx->phy_op->set_settings(efx, &ecmd);
WARN_ON(rc);
}
@@ -813,6 +797,13 @@
ecmd->duplex = (reg & (1 << GPHY_DUPLEX_LBN) ?
DUPLEX_FULL : DUPLEX_HALF);
}
+
+ /* In loopback, the PHY automatically brings up the correct interface,
+ * but doesn't advertise the correct speed. So override it */
+ if (efx->loopback_mode == LOOPBACK_GPHY)
+ ecmd->speed = SPEED_1000;
+ else if (LOOPBACK_MASK(efx) & SFT9001_LOOPBACKS)
+ ecmd->speed = SPEED_10000;
}
static int sft9001_set_settings(struct efx_nic *efx, struct ethtool_cmd *ecmd)