Fix Maple PATA IRQ assignment.

On the Maple board, the AMD8111 IDE is in legacy mode... except that it
appears on IRQ 20 instead of IRQ 15. For drivers/ide this was handled by
the architecture's "pci_get_legacy_ide_irq()" function, but in libata we
just hard-code the numbers 14 and 15.

This patch provides asm-powerpc/libata-portmap.h which maps the IRQ as
appropriate, having added a pci_dev argument to the
ATA_{PRIM,SECOND}ARY_IRQ macros.

There's probably a better way to do this -- especially if we observe
that the _only_ case in which this seemingly-generic
"pci_get_legacy_ide_irq()" function returns anything other than 14 and
15 for primary and secondary respectively is the case of the AMD8111 on
the Maple board -- couldn't we handle that with a special case in the
pata_amd driver, or perhaps with a PCI quirk for Maple to switch it into
native mode during early boot and assign resources properly?

Signed-off-by: David Woodhouse <dwmw2@infradead.org>
Signed-off-by: Jeff Garzik <jeff@garzik.org>
diff --git a/drivers/ata/Kconfig b/drivers/ata/Kconfig
index da21552..1c94b43 100644
--- a/drivers/ata/Kconfig
+++ b/drivers/ata/Kconfig
@@ -19,6 +19,10 @@
 
 if ATA
 
+config ATA_NONSTANDARD
+       bool
+       default n
+
 config SATA_AHCI
 	tristate "AHCI SATA support"
 	depends on PCI