mac80211: do not pass PS frames out of mac80211 again
In order to handle powersave frames properly we had needed
to pass these out to the device queues again, and introduce
the skb->requeue bit. This, however, also has unnecessary
overhead by needing to 'clean up' already tried frames, and
this clean-up code is also buggy when software encryption
is used.
Instead of sending the frames via the master netdev queue
again, simply put them into the pending queue. This also
fixes a problem where frames for that particular station
could be reordered when some were still on the software
queues and older ones are re-injected into the software
queue after them.
Signed-off-by: Johannes Berg <johannes@sipsolutions.net>
Signed-off-by: John W. Linville <linville@tuxdriver.com>
diff --git a/include/net/mac80211.h b/include/net/mac80211.h
index 17d61d1..c061044 100644
--- a/include/net/mac80211.h
+++ b/include/net/mac80211.h
@@ -239,6 +239,8 @@
* @IEEE80211_TX_INTFL_NEED_TXPROCESSING: completely internal to mac80211,
* used to indicate that a pending frame requires TX processing before
* it can be sent out.
+ * @IEEE80211_TX_INTFL_RETRIED: completely internal to mac80211,
+ * used to indicate that a frame was already retried due to PS
*/
enum mac80211_tx_control_flags {
IEEE80211_TX_CTL_REQ_TX_STATUS = BIT(0),
@@ -256,6 +258,7 @@
IEEE80211_TX_CTL_RATE_CTRL_PROBE = BIT(12),
IEEE80211_TX_INTFL_RCALGO = BIT(13),
IEEE80211_TX_INTFL_NEED_TXPROCESSING = BIT(14),
+ IEEE80211_TX_INTFL_RETRIED = BIT(15),
};
/**