pcmcia: do not use io_req_t when calling pcmcia_request_io()
Instead of io_req_t, drivers are now requested to fill out
struct pcmcia_device *p_dev->resource[0,1] for up to two ioport
ranges. After a call to pcmcia_request_io(), the ports found there
are reserved, after calling pcmcia_request_configuration(), they may
be used.
CC: netdev@vger.kernel.org
CC: linux-wireless@vger.kernel.org
CC: linux-ide@vger.kernel.org
CC: linux-usb@vger.kernel.org
CC: laforge@gnumonks.org
CC: linux-mtd@lists.infradead.org
CC: alsa-devel@alsa-project.org
CC: linux-serial@vger.kernel.org
CC: Michael Buesch <mb@bu3sch.de>
Acked-by: Marcel Holtmann <marcel@holtmann.org> (for drivers/bluetooth/)
Signed-off-by: Dominik Brodowski <linux@dominikbrodowski.net>
diff --git a/drivers/net/wireless/wl3501_cs.c b/drivers/net/wireless/wl3501_cs.c
index a32f220..a1cc2d4 100644
--- a/drivers/net/wireless/wl3501_cs.c
+++ b/drivers/net/wireless/wl3501_cs.c
@@ -1884,9 +1884,8 @@
struct wl3501_card *this;
/* The io structure describes IO port mapping */
- p_dev->io.NumPorts1 = 16;
- p_dev->io.Attributes1 = IO_DATA_PATH_WIDTH_8;
- p_dev->io.IOAddrLines = 5;
+ p_dev->resource[0]->end = 16;
+ p_dev->resource[0]->flags = IO_DATA_PATH_WIDTH_8;
/* General socket configuration */
p_dev->conf.Attributes = CONF_ENABLE_IRQ;
@@ -1932,13 +1931,14 @@
/* Try allocating IO ports. This tries a few fixed addresses. If you
* want, you can also read the card's config table to pick addresses --
* see the serial driver for an example. */
+ link->io_lines = 5;
for (j = 0x280; j < 0x400; j += 0x20) {
/* The '^0x300' is so that we probe 0x300-0x3ff first, then
* 0x200-0x2ff, and so on, because this seems safer */
- link->io.BasePort1 = j;
- link->io.BasePort2 = link->io.BasePort1 + 0x10;
- i = pcmcia_request_io(link, &link->io);
+ link->resource[0]->start = j;
+ link->resource[1]->start = link->resource[0]->start + 0x10;
+ i = pcmcia_request_io(link);
if (i == 0)
break;
}