b43: Add LP PHY Analog Switch Support
The current verison of b43 uses "b43_phyop_switch_analog_generic" for A,
G and LP phys.
According to the spec, this is the wrong behaviour for the LP PHY
(see: http://bcm-v4.sipsolutions.net/802.11/PHY/Anacore )
While no problems on the x86 plattform where seen, this leads to a crash
on the BCM5354 SoC (MIPS 32 LE plattform).
This patch implements the analog switch for LP PHYs according to the
specs. It fixes the crash
signed-off-by: Thomas Ilnseher <illth@gmx.de>
Signed-off-by: John W. Linville <linville@tuxdriver.com>
diff --git a/drivers/net/wireless/b43/phy_lp.c b/drivers/net/wireless/b43/phy_lp.c
index 3e02d96..1e318d8 100644
--- a/drivers/net/wireless/b43/phy_lp.c
+++ b/drivers/net/wireless/b43/phy_lp.c
@@ -2228,6 +2228,16 @@
return B43_TXPWR_RES_DONE;
}
+void b43_lpphy_op_switch_analog(struct b43_wldev *dev, bool on)
+{
+ if (on) {
+ b43_phy_mask(dev, B43_LPPHY_AFE_CTL_OVR, 0xfff8);
+ } else {
+ b43_phy_set(dev, B43_LPPHY_AFE_CTL_OVRVAL, 0x0007);
+ b43_phy_set(dev, B43_LPPHY_AFE_CTL_OVR, 0x0007);
+ }
+}
+
const struct b43_phy_operations b43_phyops_lp = {
.allocate = b43_lpphy_op_allocate,
.free = b43_lpphy_op_free,
@@ -2239,7 +2249,7 @@
.radio_read = b43_lpphy_op_radio_read,
.radio_write = b43_lpphy_op_radio_write,
.software_rfkill = b43_lpphy_op_software_rfkill,
- .switch_analog = b43_phyop_switch_analog_generic,
+ .switch_analog = b43_lpphy_op_switch_analog,
.switch_channel = b43_lpphy_op_switch_channel,
.get_default_chan = b43_lpphy_op_get_default_chan,
.set_rx_antenna = b43_lpphy_op_set_rx_antenna,