[libata scsi] add START STOP UNIT translation
diff --git a/drivers/scsi/libata-scsi.c b/drivers/scsi/libata-scsi.c
index 6a75ec2..f58311b 100644
--- a/drivers/scsi/libata-scsi.c
+++ b/drivers/scsi/libata-scsi.c
@@ -392,6 +392,60 @@
}
/**
+ * ata_scsi_start_stop_xlat - Translate SCSI START STOP UNIT command
+ * @qc: Storage for translated ATA taskfile
+ * @scsicmd: SCSI command to translate
+ *
+ * Sets up an ATA taskfile to issue STANDBY (to stop) or READ VERIFY
+ * (to start). Perhaps these commands should be preceded by
+ * CHECK POWER MODE to see what power mode the device is already in.
+ * [See SAT revision 5 at www.t10.org]
+ *
+ * LOCKING:
+ * spin_lock_irqsave(host_set lock)
+ *
+ * RETURNS:
+ * Zero on success, non-zero on error.
+ */
+
+static unsigned int ata_scsi_start_stop_xlat(struct ata_queued_cmd *qc,
+ u8 *scsicmd)
+{
+ struct ata_taskfile *tf = &qc->tf;
+
+ tf->flags |= ATA_TFLAG_DEVICE | ATA_TFLAG_ISADDR;
+ tf->protocol = ATA_PROT_NODATA;
+ if (scsicmd[1] & 0x1) {
+ ; /* ignore IMMED bit, violates sat-r05 */
+ }
+ if (scsicmd[4] & 0x2)
+ return 1; /* LOEJ bit set not supported */
+ if (((scsicmd[4] >> 4) & 0xf) != 0)
+ return 1; /* power conditions not supported */
+ if (scsicmd[4] & 0x1) {
+ tf->nsect = 1; /* 1 sector, lba=0 */
+ tf->lbah = 0x0;
+ tf->lbam = 0x0;
+ tf->lbal = 0x0;
+ tf->device |= ATA_LBA;
+ tf->command = ATA_CMD_VERIFY; /* READ VERIFY */
+ } else {
+ tf->nsect = 0; /* time period value (0 implies now) */
+ tf->command = ATA_CMD_STANDBY;
+ /* Consider: ATA STANDBY IMMEDIATE command */
+ }
+ /*
+ * Standby and Idle condition timers could be implemented but that
+ * would require libata to implement the Power condition mode page
+ * and allow the user to change it. Changing mode pages requires
+ * MODE SELECT to be implemented.
+ */
+
+ return 0;
+}
+
+
+/**
* ata_scsi_flush_xlat - Translate SCSI SYNCHRONIZE CACHE command
* @qc: Storage for translated ATA taskfile
* @scsicmd: SCSI command to translate (ignored)
@@ -1435,6 +1489,8 @@
case VERIFY:
case VERIFY_16:
return ata_scsi_verify_xlat;
+ case START_STOP:
+ return ata_scsi_start_stop_xlat;
}
return NULL;