arch/arm/plat-orion/gpio.c

/*
 * arch/arm/plat-orion/gpio.c
 *
 * Marvell Orion SoC GPIO handling.
 *
 * This file is licensed under the terms of the GNU General Public
 * License version 2.  This program is licensed "as is" without any
 * warranty of any kind, whether express or implied.
 */

#include <linux/kernel.h>
#include <linux/init.h>
#include <linux/irq.h>
#include <linux/module.h>
#include <linux/spinlock.h>
#include <linux/bitops.h>
#include <linux/io.h>
#include <linux/gpio.h>

static DEFINE_SPINLOCK(gpio_lock);
static unsigned long gpio_valid_input[BITS_TO_LONGS(GPIO_MAX)];
static unsigned long gpio_valid_output[BITS_TO_LONGS(GPIO_MAX)];

static inline void __set_direction(unsigned pin, int input)
{
	u32 u;

	u = readl(GPIO_IO_CONF(pin));
	if (input)
		u |= 1 << (pin & 31);
	else
		u &= ~(1 << (pin & 31));
	writel(u, GPIO_IO_CONF(pin));
}

static void __set_level(unsigned pin, int high)
{
	u32 u;

	u = readl(GPIO_OUT(pin));
	if (high)
		u |= 1 << (pin & 31);
	else
		u &= ~(1 << (pin & 31));
	writel(u, GPIO_OUT(pin));
}

static inline void __set_blinking(unsigned pin, int blink)
{
	u32 u;

	u = readl(GPIO_BLINK_EN(pin));
	if (blink)
		u |= 1 << (pin & 31);
	else
		u &= ~(1 << (pin & 31));
	writel(u, GPIO_BLINK_EN(pin));
}

static inline int orion_gpio_is_valid(unsigned pin, int mode)
{
	if (pin < GPIO_MAX) {
		if ((mode & GPIO_INPUT_OK) && !test_bit(pin, gpio_valid_input))
			goto err_out;
		if ((mode & GPIO_OUTPUT_OK) && !test_bit(pin, gpio_valid_output))
			goto err_out;
		return true;
	}

err_out:
	pr_debug("%s: invalid GPIO %d\n", __func__, pin);
	return false;
}

/*
 * GENERIC_GPIO primitives.
 */
static int orion_gpio_direction_input(struct gpio_chip *chip, unsigned pin)
{
	unsigned long flags;

	if (!orion_gpio_is_valid(pin, GPIO_INPUT_OK))
		return -EINVAL;

	spin_lock_irqsave(&gpio_lock, flags);

	/* Configure GPIO direction. */
	__set_direction(pin, 1);

	spin_unlock_irqrestore(&gpio_lock, flags);

	return 0;
}

static int orion_gpio_get_value(struct gpio_chip *chip, unsigned pin)
{
	int val;

	if (readl(GPIO_IO_CONF(pin)) & (1 << (pin & 31)))
		val = readl(GPIO_DATA_IN(pin)) ^ readl(GPIO_IN_POL(pin));
	else
		val = readl(GPIO_OUT(pin));

	return (val >> (pin & 31)) & 1;
}

static int orion_gpio_direction_output(struct gpio_chip *chip, unsigned pin,
	int value)
{
	unsigned long flags;

	if (!orion_gpio_is_valid(pin, GPIO_OUTPUT_OK))
		return -EINVAL;

	spin_lock_irqsave(&gpio_lock, flags);

	/* Disable blinking. */
	__set_blinking(pin, 0);

	/* Configure GPIO output value. */
	__set_level(pin, value);

	/* Configure GPIO direction. */
	__set_direction(pin, 0);

	spin_unlock_irqrestore(&gpio_lock, flags);

	return 0;
}

static void orion_gpio_set_value(struct gpio_chip *chip, unsigned pin,
	int value)
{
	unsigned long flags;

	spin_lock_irqsave(&gpio_lock, flags);

	/* Configure GPIO output value. */
	__set_level(pin, value);

	spin_unlock_irqrestore(&gpio_lock, flags);
}

static int orion_gpio_request(struct gpio_chip *chip, unsigned pin)
{
	if (orion_gpio_is_valid(pin, GPIO_INPUT_OK) ||
	    orion_gpio_is_valid(pin, GPIO_OUTPUT_OK))
		return 0;
	return -EINVAL;
}

static struct gpio_chip orion_gpiochip = {
	.label			= "orion_gpio",
	.direction_input	= orion_gpio_direction_input,
	.get			= orion_gpio_get_value,
	.direction_output	= orion_gpio_direction_output,
	.set			= orion_gpio_set_value,
	.request		= orion_gpio_request,
	.base			= 0,
	.ngpio			= GPIO_MAX,
	.can_sleep		= 0,
};

void __init orion_gpio_init(void)
{
	gpiochip_add(&orion_gpiochip);
}

/*
 * Orion-specific GPIO API extensions.
 */
void __init orion_gpio_set_unused(unsigned pin)
{
	/* Configure as output, drive low. */
	__set_level(pin, 0);
	__set_direction(pin, 0);
}

void __init orion_gpio_set_valid(unsigned pin, int mode)
{
	if (mode == 1)
		mode = GPIO_INPUT_OK | GPIO_OUTPUT_OK;
	if (mode & GPIO_INPUT_OK)
		__set_bit(pin, gpio_valid_input);
	else
		__clear_bit(pin, gpio_valid_input);
	if (mode & GPIO_OUTPUT_OK)
		__set_bit(pin, gpio_valid_output);
	else
		__clear_bit(pin, gpio_valid_output);
}

void orion_gpio_set_blink(unsigned pin, int blink)
{
	unsigned long flags;

	spin_lock_irqsave(&gpio_lock, flags);

	/* Set output value to zero. */
	__set_level(pin, 0);

	/* Set blinking. */
	__set_blinking(pin, blink);

	spin_unlock_irqrestore(&gpio_lock, flags);
}
EXPORT_SYMBOL(orion_gpio_set_blink);


/*****************************************************************************
 * Orion GPIO IRQ
 *
 * GPIO_IN_POL register controls whether GPIO_DATA_IN will hold the same
 * value of the line or the opposite value.
 *
 * Level IRQ handlers: DATA_IN is used directly as cause register.
 *                     Interrupt are masked by LEVEL_MASK registers.
 * Edge IRQ handlers:  Change in DATA_IN are latched in EDGE_CAUSE.
 *                     Interrupt are masked by EDGE_MASK registers.
 * Both-edge handlers: Similar to regular Edge handlers, but also swaps
 *                     the polarity to catch the next line transaction.
 *                     This is a race condition that might not perfectly
 *                     work on some use cases.
 *
 * Every eight GPIO lines are grouped (OR'ed) before going up to main
 * cause register.
 *
 *                    EDGE  cause    mask
 *        data-in   /--------| |-----| |----\
 *     -----| |-----                         ---- to main cause reg
 *           X      \----------------| |----/
 *        polarity    LEVEL          mask
 *
 ****************************************************************************/
static void gpio_irq_ack(struct irq_data *d)
{
	int type = irq_desc[d->irq].status & IRQ_TYPE_SENSE_MASK;
	if (type & (IRQ_TYPE_EDGE_RISING | IRQ_TYPE_EDGE_FALLING)) {
		int pin = irq_to_gpio(d->irq);
		writel(~(1 << (pin & 31)), GPIO_EDGE_CAUSE(pin));
	}
}

static void gpio_irq_mask(struct irq_data *d)
{
	int pin = irq_to_gpio(d->irq);
	int type = irq_desc[d->irq].status & IRQ_TYPE_SENSE_MASK;
	u32 reg = (type & (IRQ_TYPE_EDGE_RISING | IRQ_TYPE_EDGE_FALLING)) ?
		GPIO_EDGE_MASK(pin) : GPIO_LEVEL_MASK(pin);
	u32 u = readl(reg);
	u &= ~(1 << (pin & 31));
	writel(u, reg);
}

static void gpio_irq_unmask(struct irq_data *d)
{
	int pin = irq_to_gpio(d->irq);
	int type = irq_desc[d->irq].status & IRQ_TYPE_SENSE_MASK;
	u32 reg = (type & (IRQ_TYPE_EDGE_RISING | IRQ_TYPE_EDGE_FALLING)) ?
		GPIO_EDGE_MASK(pin) : GPIO_LEVEL_MASK(pin);
	u32 u = readl(reg);
	u |= 1 << (pin & 31);
	writel(u, reg);
}

static int gpio_irq_set_type(struct irq_data *d, u32 type)
{
	int pin = irq_to_gpio(d->irq);
	struct irq_desc *desc;
	u32 u;

	u = readl(GPIO_IO_CONF(pin)) & (1 << (pin & 31));
	if (!u) {
		printk(KERN_ERR "orion gpio_irq_set_type failed "
				"(irq %d, pin %d).\n", d->irq, pin);
		return -EINVAL;
	}

	desc = irq_desc + d->irq;

	/*
	 * Set edge/level type.
	 */
	if (type & (IRQ_TYPE_EDGE_RISING | IRQ_TYPE_EDGE_FALLING)) {
		desc->handle_irq = handle_edge_irq;
	} else if (type & (IRQ_TYPE_LEVEL_HIGH | IRQ_TYPE_LEVEL_LOW)) {
		desc->handle_irq = handle_level_irq;
	} else {
		printk(KERN_ERR "failed to set irq=%d (type=%d)\n", d->irq, type);
		return -EINVAL;
	}

	/*
	 * Configure interrupt polarity.
	 */
	if (type == IRQ_TYPE_EDGE_RISING || type == IRQ_TYPE_LEVEL_HIGH) {
		u = readl(GPIO_IN_POL(pin));
		u &= ~(1 << (pin & 31));
		writel(u, GPIO_IN_POL(pin));
	} else if (type == IRQ_TYPE_EDGE_FALLING || type == IRQ_TYPE_LEVEL_LOW) {
		u = readl(GPIO_IN_POL(pin));
		u |= 1 << (pin & 31);
		writel(u, GPIO_IN_POL(pin));
	} else if (type == IRQ_TYPE_EDGE_BOTH) {
		u32 v;

		v = readl(GPIO_IN_POL(pin)) ^ readl(GPIO_DATA_IN(pin));

		/*
		 * set initial polarity based on current input level
		 */
		u = readl(GPIO_IN_POL(pin));
		if (v & (1 << (pin & 31)))
			u |= 1 << (pin & 31);		/* falling */
		else
			u &= ~(1 << (pin & 31));	/* rising */
		writel(u, GPIO_IN_POL(pin));
	}

	desc->status = (desc->status & ~IRQ_TYPE_SENSE_MASK) | type;

	return 0;
}

struct irq_chip orion_gpio_irq_chip = {
	.name		= "orion_gpio_irq",
	.irq_ack	= gpio_irq_ack,
	.irq_mask	= gpio_irq_mask,
	.irq_unmask	= gpio_irq_unmask,
	.irq_set_type	= gpio_irq_set_type,
};

void orion_gpio_irq_handler(int pinoff)
{
	u32 cause;
	int pin;

	cause = readl(GPIO_DATA_IN(pinoff)) & readl(GPIO_LEVEL_MASK(pinoff));
	cause |= readl(GPIO_EDGE_CAUSE(pinoff)) & readl(GPIO_EDGE_MASK(pinoff));

	for (pin = pinoff; pin < pinoff + 8; pin++) {
		int irq = gpio_to_irq(pin);
		struct irq_desc *desc = irq_desc + irq;

		if (!(cause & (1 << (pin & 31))))
			continue;

		if ((desc->status & IRQ_TYPE_SENSE_MASK) == IRQ_TYPE_EDGE_BOTH) {
			/* Swap polarity (race with GPIO line) */
			u32 polarity;

			polarity = readl(GPIO_IN_POL(pin));
			polarity ^= 1 << (pin & 31);
			writel(polarity, GPIO_IN_POL(pin));
		}
		desc_handle_irq(irq, desc);
	}
}