pcmcia: do not use io_req_t after call to pcmcia_request_io()
After pcmcia_request_io(), do not make use of the values stored in
io_req_t, but instead use those found in struct pcmcia_device->resource[].
CC: netdev@vger.kernel.org
CC: linux-wireless@vger.kernel.org
CC: linux-ide@vger.kernel.org
CC: linux-usb@vger.kernel.org
CC: laforge@gnumonks.org
CC: linux-mtd@lists.infradead.org
CC: alsa-devel@alsa-project.org
CC: linux-serial@vger.kernel.org
Acked-by: Marcel Holtmann <marcel@holtmann.org> (for drivers/bluetooth/)
Signed-off-by: Dominik Brodowski <linux@dominikbrodowski.net>
diff --git a/drivers/isdn/hisax/teles_cs.c b/drivers/isdn/hisax/teles_cs.c
index d3fb1b7..3787fc7 100644
--- a/drivers/isdn/hisax/teles_cs.c
+++ b/drivers/isdn/hisax/teles_cs.c
@@ -194,23 +194,21 @@
link->conf.ConfigIndex);
if (link->conf.Attributes & CONF_ENABLE_IRQ)
printk(", irq %d", link->irq);
- if (link->io.NumPorts1)
- printk(", io 0x%04x-0x%04x", link->io.BasePort1,
- link->io.BasePort1+link->io.NumPorts1-1);
- if (link->io.NumPorts2)
- printk(" & 0x%04x-0x%04x", link->io.BasePort2,
- link->io.BasePort2+link->io.NumPorts2-1);
+ if (link->resource[0])
+ printk(" & %pR", link->resource[0]);
+ if (link->resource[1])
+ printk(" & %pR", link->resource[1]);
printk("\n");
icard.para[0] = link->irq;
- icard.para[1] = link->io.BasePort1;
+ icard.para[1] = link->resource[0]->start;
icard.protocol = protocol;
icard.typ = ISDN_CTYPE_TELESPCMCIA;
i = hisax_init_pcmcia(link, &(((local_info_t*)link->priv)->busy), &icard);
if (i < 0) {
printk(KERN_ERR "teles_cs: failed to initialize Teles PCMCIA %d at i/o %#x\n",
- i, link->io.BasePort1);
+ i, (unsigned int) link->resource[0]->start);
teles_cs_release(link);
return -ENODEV;
}