mmc: omap_hsmmc: if multiblock reads are broken, disable them
When device data indicates that multiple block reads are not supported
on a given HSMMC controller instance, log a message to the console, and
pass the appropriate MMC capability flag to the MMC core.
Signed-off-by: Paul Walmsley <paul@pwsan.com>
Cc: Dave Hylands <dhylands@gmail.com>
Tested-by: Steve Sakoman <sakoman@gmail.com>
Signed-off-by: Chris Ball <cjb@laptop.org>
diff --git a/arch/arm/plat-omap/include/plat/mmc.h b/arch/arm/plat-omap/include/plat/mmc.h
index c7b8741..94cf70a 100644
--- a/arch/arm/plat-omap/include/plat/mmc.h
+++ b/arch/arm/plat-omap/include/plat/mmc.h
@@ -31,7 +31,24 @@
#define OMAP_MMC_MAX_SLOTS 2
-#define OMAP_HSMMC_SUPPORTS_DUAL_VOLT BIT(1)
+/*
+ * struct omap_mmc_dev_attr.flags possibilities
+ *
+ * OMAP_HSMMC_SUPPORTS_DUAL_VOLT: Some HSMMC controller instances can
+ * operate with either 1.8Vdc or 3.0Vdc card voltages; this flag
+ * should be set if this is the case. See for example Section 22.5.3
+ * "MMC/SD/SDIO1 Bus Voltage Selection" of the OMAP34xx Multimedia
+ * Device Silicon Revision 3.1.x Revision ZR (July 2011) (SWPU223R).
+ *
+ * OMAP_HSMMC_BROKEN_MULTIBLOCK_READ: Multiple-block read transfers
+ * don't work correctly on some MMC controller instances on some
+ * OMAP3 SoCs; this flag should be set if this is the case. See
+ * for example Advisory 2.1.1.128 "MMC: Multiple Block Read
+ * Operation Issue" in _OMAP3530/3525/3515/3503 Silicon Errata_
+ * Revision F (October 2010) (SPRZ278F).
+ */
+#define OMAP_HSMMC_SUPPORTS_DUAL_VOLT BIT(0)
+#define OMAP_HSMMC_BROKEN_MULTIBLOCK_READ BIT(1)
struct omap_mmc_dev_attr {
u8 flags;
diff --git a/drivers/mmc/host/omap_hsmmc.c b/drivers/mmc/host/omap_hsmmc.c
index bb334be..e8ff123 100644
--- a/drivers/mmc/host/omap_hsmmc.c
+++ b/drivers/mmc/host/omap_hsmmc.c
@@ -1942,6 +1942,10 @@
omap_hsmmc_context_save(host);
mmc->caps |= MMC_CAP_DISABLE;
+ if (host->pdata->controller_flags & OMAP_HSMMC_BROKEN_MULTIBLOCK_READ) {
+ dev_info(&pdev->dev, "multiblock reads disabled due to 35xx erratum 2.1.1.128; MMC read performance may suffer\n");
+ mmc->caps2 |= MMC_CAP2_NO_MULTI_READ;
+ }
pm_runtime_enable(host->dev);
pm_runtime_get_sync(host->dev);