[netdrvr] use dev_xxx() printk helpers, rather than dev_printk(KERN_xxx, ...
Suggested by Jiri Slaby.
Signed-off-by: Jeff Garzik <jeff@garzik.org>
diff --git a/drivers/net/epic100.c b/drivers/net/epic100.c
index 6dd0e9d..a67650cc 100644
--- a/drivers/net/epic100.c
+++ b/drivers/net/epic100.c
@@ -335,7 +335,7 @@
irq = pdev->irq;
if (pci_resource_len(pdev, 0) < EPIC_TOTAL_SIZE) {
- dev_printk(KERN_ERR, &pdev->dev, "no PCI region space\n");
+ dev_err(&pdev->dev, "no PCI region space\n");
ret = -ENODEV;
goto err_out_disable;
}
@@ -350,7 +350,7 @@
dev = alloc_etherdev(sizeof (*ep));
if (!dev) {
- dev_printk(KERN_ERR, &pdev->dev, "no memory for eth device\n");
+ dev_err(&pdev->dev, "no memory for eth device\n");
goto err_out_free_res;
}
SET_MODULE_OWNER(dev);
@@ -362,7 +362,7 @@
ioaddr = pci_resource_start (pdev, 1);
ioaddr = (long) ioremap (ioaddr, pci_resource_len (pdev, 1));
if (!ioaddr) {
- dev_printk(KERN_ERR, &pdev->dev, "ioremap failed\n");
+ dev_err(&pdev->dev, "ioremap failed\n");
goto err_out_free_netdev;
}
#endif
@@ -444,7 +444,7 @@
int mii_status = mdio_read(dev, phy, MII_BMSR);
if (mii_status != 0xffff && mii_status != 0x0000) {
ep->phys[phy_idx++] = phy;
- dev_printk(KERN_INFO, &pdev->dev,
+ dev_info(&pdev->dev,
"MII transceiver #%d control "
"%4.4x status %4.4x.\n",
phy, mdio_read(dev, phy, 0), mii_status);
@@ -454,12 +454,12 @@
if (phy_idx != 0) {
phy = ep->phys[0];
ep->mii.advertising = mdio_read(dev, phy, MII_ADVERTISE);
- dev_printk(KERN_INFO, &pdev->dev,
+ dev_info(&pdev->dev,
"Autonegotiation advertising %4.4x link "
"partner %4.4x.\n",
ep->mii.advertising, mdio_read(dev, phy, 5));
} else if ( ! (ep->chip_flags & NO_MII)) {
- dev_printk(KERN_WARNING, &pdev->dev,
+ dev_warn(&pdev->dev,
"***WARNING***: No MII transceiver found!\n");
/* Use the known PHY address of the EPII. */
ep->phys[0] = 3;
@@ -475,8 +475,7 @@
/* The lower four bits are the media type. */
if (duplex) {
ep->mii.force_media = ep->mii.full_duplex = 1;
- dev_printk(KERN_INFO, &pdev->dev,
- "Forced full duplex operation requested.\n");
+ dev_info(&pdev->dev, "Forced full duplex requested.\n");
}
dev->if_port = ep->default_port = option;