| # |
| # linux/drivers/mtd/onenand/Kconfig |
| # |
| |
| menu "OneNAND Flash Device Drivers" |
| depends on MTD != n |
| |
| config MTD_ONENAND |
| tristate "OneNAND Device Support" |
| depends on MTD |
| help |
| This enables support for accessing all type of OneNAND flash |
| devices. For further information see |
| <http://www.samsung.com/Products/Semiconductor/Flash/OneNAND_TM/index.htm>. |
| |
| config MTD_ONENAND_VERIFY_WRITE |
| bool "Verify OneNAND page writes" |
| depends on MTD_ONENAND |
| help |
| This adds an extra check when data is written to the flash. The |
| OneNAND flash device internally checks only bits transitioning |
| from 1 to 0. There is a rare possibility that even though the |
| device thinks the write was successful, a bit could have been |
| flipped accidentaly due to device wear or something else. |
| |
| config MTD_ONENAND_GENERIC |
| tristate "OneNAND Flash device via platform device driver" |
| depends on MTD_ONENAND && ARM |
| help |
| Support for OneNAND flash via platform device driver. |
| |
| config MTD_ONENAND_OTP |
| bool "OneNAND OTP Support" |
| depends on MTD_ONENAND |
| help |
| One Block of the NAND Flash Array memory is reserved as |
| a One-Time Programmable Block memory area. |
| Also, 1st Block of NAND Flash Array can be used as OTP. |
| |
| The OTP block can be read, programmed and locked using the same |
| operations as any other NAND Flash Array memory block. |
| OTP block cannot be erased. |
| |
| OTP block is fully-guaranteed to be a valid block. |
| |
| config MTD_ONENAND_SYNC_READ |
| bool "OneNAND Sync. Burst Read Support" |
| depends on ARCH_OMAP |
| help |
| This enables support for Sync. Burst Read. |
| |
| endmenu |