ath5k: clean up some comments
This fixes a few misspellings, word repetitions, and some grammar
nits in ath5k comments. No code changes.
Signed-off-by: Bob Copeland <me@bobcopeland.com>
Signed-off-by: John W. Linville <linville@tuxdriver.com>
diff --git a/drivers/net/wireless/ath/ath5k/phy.c b/drivers/net/wireless/ath/ath5k/phy.c
index 6284c38..c7c4465 100644
--- a/drivers/net/wireless/ath/ath5k/phy.c
+++ b/drivers/net/wireless/ath/ath5k/phy.c
@@ -115,7 +115,7 @@
\**********************/
/*
- * This code is used to optimize rf gain on different environments
+ * This code is used to optimize RF gain on different environments
* (temperature mostly) based on feedback from a power detector.
*
* It's only used on RF5111 and RF5112, later RF chips seem to have
@@ -302,7 +302,7 @@
}
/* Perform gain_F adjustment by choosing the right set
- * of parameters from rf gain optimization ladder */
+ * of parameters from RF gain optimization ladder */
static s8 ath5k_hw_rf_gainf_adjust(struct ath5k_hw *ah)
{
const struct ath5k_gain_opt *go;
@@ -367,7 +367,7 @@
return ret;
}
-/* Main callback for thermal rf gain calibration engine
+/* Main callback for thermal RF gain calibration engine
* Check for a new gain reading and schedule an adjustment
* if needed.
*
@@ -433,7 +433,7 @@
return ah->ah_gain.g_state;
}
-/* Write initial rf gain table to set the RF sensitivity
+/* Write initial RF gain table to set the RF sensitivity
* this one works on all RF chips and has nothing to do
* with gain_F calibration */
int ath5k_hw_rfgain_init(struct ath5k_hw *ah, unsigned int freq)
@@ -496,7 +496,7 @@
/*
- * Setup RF registers by writing rf buffer on hw
+ * Setup RF registers by writing RF buffer on hw
*/
int ath5k_hw_rfregs_init(struct ath5k_hw *ah, struct ieee80211_channel *channel,
unsigned int mode)
@@ -571,7 +571,7 @@
return -EINVAL;
}
- /* If it's the first time we set rf buffer, allocate
+ /* If it's the first time we set RF buffer, allocate
* ah->ah_rf_banks based on ah->ah_rf_banks_size
* we set above */
if (ah->ah_rf_banks == NULL) {
@@ -3035,9 +3035,6 @@
/* Limit max power if we have a CTL available */
ath5k_get_max_ctl_power(ah, channel);
- /* FIXME: Tx power limit for this regdomain
- * XXX: Mac80211/CRDA will do that anyway ? */
-
/* FIXME: Antenna reduction stuff */
/* FIXME: Limit power on turbo modes */