mv643xx_eth: remove port serial status register bit defines
All except one of the port serial status register bit defines are
unused -- kill the unused ones.
Signed-off-by: Lennert Buytenhek <buytenh@marvell.com>
Acked-by: Dale Farnsworth <dale@farnsworth.org>
diff --git a/drivers/net/mv643xx_eth.c b/drivers/net/mv643xx_eth.c
index bcc891d..6324556 100644
--- a/drivers/net/mv643xx_eth.c
+++ b/drivers/net/mv643xx_eth.c
@@ -103,6 +103,7 @@
#define SDMA_CONFIG(p) (0x041c + ((p) << 10))
#define PORT_SERIAL_CONTROL(p) (0x043c + ((p) << 10))
#define PORT_STATUS(p) (0x0444 + ((p) << 10))
+#define TX_FIFO_EMPTY 0x00000400
#define TXQ_COMMAND(p) (0x0448 + ((p) << 10))
#define TX_BW_MTU(p) (0x0458 + ((p) << 10))
#define INT_CAUSE(p) (0x0460 + ((p) << 10))
@@ -169,18 +170,6 @@
#define PORT_DEFAULT_TRANSMIT_QUEUE_SIZE 800
#define PORT_DEFAULT_RECEIVE_QUEUE_SIZE 400
-/* Port serial status reg (PSR) */
-#define ETH_INTERFACE_PCM 0x00000001
-#define ETH_LINK_IS_UP 0x00000002
-#define ETH_PORT_AT_FULL_DUPLEX 0x00000004
-#define ETH_RX_FLOW_CTRL_ENABLED 0x00000008
-#define ETH_GMII_SPEED_1000 0x00000010
-#define ETH_MII_SPEED_100 0x00000020
-#define ETH_TX_IN_PROGRESS 0x00000080
-#define ETH_BYPASS_ACTIVE 0x00000100
-#define ETH_PORT_AT_PARTITION_STATE 0x00000200
-#define ETH_PORT_TX_FIFO_EMPTY 0x00000400
-
/* SMI reg */
#define ETH_SMI_BUSY 0x10000000 /* 0 - Write, 1 - Read */
#define ETH_SMI_READ_VALID 0x08000000 /* 0 - Write, 1 - Read */
@@ -471,7 +460,7 @@
udelay(10);
/* Wait for Tx FIFO to empty */
- while (rdl(mp, PORT_STATUS(port_num)) & ETH_PORT_TX_FIFO_EMPTY)
+ while (rdl(mp, PORT_STATUS(port_num)) & TX_FIFO_EMPTY)
udelay(10);
}