pata_hpt37x: Further small fixes
Further HPT37x changes
- No 66MHz 370/370A
- Remove dead special case check now we use the DPLL (as per the IDE driver)
Pointed out by Sergei
Signed-off-by: Alan Cox <alan@redhat.com>
Signed-off-by: Andrew Morton <akpm@linux-foundation.org>
Signed-off-by: Jeff Garzik <jeff@garzik.org>
diff --git a/drivers/ata/pata_hpt37x.c b/drivers/ata/pata_hpt37x.c
index fe1b482..41d83129 100644
--- a/drivers/ata/pata_hpt37x.c
+++ b/drivers/ata/pata_hpt37x.c
@@ -26,7 +26,7 @@
#include <linux/libata.h>
#define DRV_NAME "pata_hpt37x"
-#define DRV_VERSION "0.6.4"
+#define DRV_VERSION "0.6.5"
struct hpt_clock {
u8 xfer_speed;
@@ -130,7 +130,7 @@
hpt37x_timings_33,
NULL,
NULL,
- hpt37x_timings_66
+ NULL
}
};
@@ -141,7 +141,7 @@
hpt37x_timings_33,
NULL,
hpt37x_timings_50,
- hpt37x_timings_66
+ NULL
}
};
@@ -1018,8 +1018,8 @@
return -ENODEV;
port = &info_hpt372;
chip_table = &hpt371;
- /* Single channel device, paster is not present
- but the NIOS (or us for non x86) must mark it
+ /* Single channel device, master is not present
+ but the BIOS (or us for non x86) must mark it
absent */
pci_read_config_byte(dev, 0x50, &mcr1);
mcr1 &= ~0x04;
@@ -1131,16 +1131,11 @@
} else {
port->private_data = (void *)chip_table->clocks[clock_slot];
/*
- * Perform a final fixup. The 371 and 372 clock determines
- * if UDMA133 is available. (FIXME: should we use DPLL then ?)
- */
+ * Perform a final fixup. Note that we will have used the
+ * DPLL on the HPT372 which means we don't have to worry
+ * about lack of UDMA133 support on lower clocks
+ */
- if (clock_slot == 2 && chip_table == &hpt372) { /* 50Mhz */
- printk(KERN_WARNING "pata_hpt37x: No UDMA133 support available with 50MHz bus clock.\n");
- if (port == &info_hpt372)
- port = &info_hpt372_50;
- else BUG();
- }
if (clock_slot < 2 && port == &info_hpt370)
port = &info_hpt370_33;
if (clock_slot < 2 && port == &info_hpt370a)