fbdev: hecuba Framebuffer Driver
This patch implements support for the E-Ink/hecuba display device. It uses
deferred IO support.
[akpm@linux-foundation.org: linker section fixes]
Signed-off-by: Jaya Kumar <jayakumar.lkml@gmail.com>
Signed-off-by: Antonino Daplas <adaplas@gmail.com>
Signed-off-by: Andrew Morton <akpm@linux-foundation.org>
Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>
diff --git a/drivers/video/Kconfig b/drivers/video/Kconfig
index 61c0a03..0aeab4e 100644
--- a/drivers/video/Kconfig
+++ b/drivers/video/Kconfig
@@ -557,6 +557,20 @@
help
This is the frame buffer device driver for the Intel-based Macintosh
+config FB_HECUBA
+ tristate "Hecuba board support"
+ depends on FB && X86 && MMU
+ select FB_CFB_FILLRECT
+ select FB_CFB_COPYAREA
+ select FB_CFB_IMAGEBLIT
+ select FB_DEFERRED_IO
+ help
+ This enables support for the Hecuba board. This driver was tested
+ with an E-Ink 800x600 display and x86 SBCs through a 16 bit GPIO
+ interface (8 bit data, 4 bit control). If you anticpate using
+ this driver, say Y or M; otherwise say N. You must specify the
+ GPIO IO address to be used for setting control and data.
+
config FB_HGA
tristate "Hercules mono graphics support"
depends on FB && X86