[PATCH] pcmcia: conf.ConfigBase and conf.Present consolidation
struct pcmcia_device *p_dev->conf.ConfigBase and .Present are set in almost
all PCMICA driver right at the beginning, using the same calls but slightly
different implementations. Unfiy this in the PCMCIA core.
Includes a small bugfix ("drivers/net/pcmcia/xirc2ps_cs.c: remove unused
label") from and Signed-off-by Adrian Bunk <bunk@stusta.de>
Signed-off-by: Dominik Brodowski <linux@dominikbrodowski.net>
diff --git a/drivers/net/pcmcia/3c574_cs.c b/drivers/net/pcmcia/3c574_cs.c
index 420f70b..794cc61 100644
--- a/drivers/net/pcmcia/3c574_cs.c
+++ b/drivers/net/pcmcia/3c574_cs.c
@@ -338,7 +338,6 @@
struct net_device *dev = link->priv;
struct el3_private *lp = netdev_priv(dev);
tuple_t tuple;
- cisparse_t parse;
unsigned short buf[32];
int last_fn, last_ret, i, j;
kio_addr_t ioaddr;
@@ -350,17 +349,6 @@
DEBUG(0, "3c574_config(0x%p)\n", link);
- tuple.Attributes = 0;
- tuple.DesiredTuple = CISTPL_CONFIG;
- CS_CHECK(GetFirstTuple, pcmcia_get_first_tuple(link, &tuple));
- tuple.TupleData = (cisdata_t *)buf;
- tuple.TupleDataMax = 64;
- tuple.TupleOffset = 0;
- CS_CHECK(GetTupleData, pcmcia_get_tuple_data(link, &tuple));
- CS_CHECK(ParseTuple, pcmcia_parse_tuple(link, &tuple, &parse));
- link->conf.ConfigBase = parse.config.base;
- link->conf.Present = parse.config.rmask[0];
-
link->io.IOAddrLines = 16;
for (i = j = 0; j < 0x400; j += 0x20) {
link->io.BasePort1 = j ^ 0x300;
@@ -382,6 +370,10 @@
/* The 3c574 normally uses an EEPROM for configuration info, including
the hardware address. The future products may include a modem chip
and put the address in the CIS. */
+ tuple.Attributes = 0;
+ tuple.TupleData = (cisdata_t *)buf;
+ tuple.TupleDataMax = 64;
+ tuple.TupleOffset = 0;
tuple.DesiredTuple = 0x88;
if (pcmcia_get_first_tuple(link, &tuple) == CS_SUCCESS) {
pcmcia_get_tuple_data(link, &tuple);