MIPS: BCM63XX: generate WLAN MAC address after registering ethernet devices.
In case the MAC address pool is not big enough to also register a WLAN device
prefer registering the Ethernet devices.
[ralf@linux-mips.org: Fixed formatting as per Sergei's complaint.]
Signed-off-by: Florian Fainelli <florian@openwrt.org>
Cc: linux-mips@linux-mips.org
Patchwork: https://patchwork.linux-mips.org/patch/3013/
Signed-off-by: Ralf Baechle <ralf@linux-mips.org>
diff --git a/arch/mips/bcm63xx/boards/board_bcm963xx.c b/arch/mips/bcm63xx/boards/board_bcm963xx.c
index ac948c2..e62461f 100644
--- a/arch/mips/bcm63xx/boards/board_bcm963xx.c
+++ b/arch/mips/bcm63xx/boards/board_bcm963xx.c
@@ -791,18 +791,6 @@
}
bcm_gpio_writel(val, GPIO_MODE_REG);
-
- /* Generate MAC address for WLAN and
- * register our SPROM */
-#ifdef CONFIG_SSB_PCIHOST
- if (!board_get_mac_address(bcm63xx_sprom.il0mac)) {
- memcpy(bcm63xx_sprom.et0mac, bcm63xx_sprom.il0mac, ETH_ALEN);
- memcpy(bcm63xx_sprom.et1mac, bcm63xx_sprom.il0mac, ETH_ALEN);
- if (ssb_arch_register_fallback_sprom(
- &bcm63xx_get_fallback_sprom) < 0)
- printk(KERN_ERR PFX "failed to register fallback SPROM\n");
- }
-#endif
}
/*
@@ -886,6 +874,19 @@
if (board.has_dsp)
bcm63xx_dsp_register(&board.dsp);
+ /* Generate MAC address for WLAN and register our SPROM,
+ * do this after registering enet devices
+ */
+#ifdef CONFIG_SSB_PCIHOST
+ if (!board_get_mac_address(bcm63xx_sprom.il0mac)) {
+ memcpy(bcm63xx_sprom.et0mac, bcm63xx_sprom.il0mac, ETH_ALEN);
+ memcpy(bcm63xx_sprom.et1mac, bcm63xx_sprom.il0mac, ETH_ALEN);
+ if (ssb_arch_register_fallback_sprom(
+ &bcm63xx_get_fallback_sprom) < 0)
+ pr_err(PFX "failed to register fallback SPROM\n");
+ }
+#endif
+
/* read base address of boot chip select (0) */
val = bcm_mpi_readl(MPI_CSBASE_REG(0));
val &= MPI_CSBASE_BASE_MASK;