powerpc/cpm2_pic: Allow correct flow_types for port C interrupts
Port C interrupts can be either falling edge, or either edge.
Other external interrupts are either falling edge or active low.
Tested on a custom 8280 based board.
Signed-off-by: Mark Ware <mware@elphinstone.net>
Acked-by: Anton Vorontsov <avorontsov@ru.mvista.com>
Acked-by: Scott Wood <scottwood@freescale.com>
Signed-off-by: Kumar Gala <galak@kernel.crashing.org>
diff --git a/arch/powerpc/sysdev/cpm2_pic.c b/arch/powerpc/sysdev/cpm2_pic.c
index 971483f..1709ac5 100644
--- a/arch/powerpc/sysdev/cpm2_pic.c
+++ b/arch/powerpc/sysdev/cpm2_pic.c
@@ -143,13 +143,23 @@
struct irq_desc *desc = irq_to_desc(virq);
unsigned int vold, vnew, edibit;
- if (flow_type == IRQ_TYPE_NONE)
- flow_type = IRQ_TYPE_LEVEL_LOW;
+ /* Port C interrupts are either IRQ_TYPE_EDGE_FALLING or
+ * IRQ_TYPE_EDGE_BOTH (default). All others are IRQ_TYPE_EDGE_FALLING
+ * or IRQ_TYPE_LEVEL_LOW (default)
+ */
+ if (src >= CPM2_IRQ_PORTC15 && src <= CPM2_IRQ_PORTC0) {
+ if (flow_type == IRQ_TYPE_NONE)
+ flow_type = IRQ_TYPE_EDGE_BOTH;
- if (flow_type & IRQ_TYPE_EDGE_RISING) {
- printk(KERN_ERR "CPM2 PIC: sense type 0x%x not supported\n",
- flow_type);
- return -EINVAL;
+ if (flow_type != IRQ_TYPE_EDGE_BOTH &&
+ flow_type != IRQ_TYPE_EDGE_FALLING)
+ goto err_sense;
+ } else {
+ if (flow_type == IRQ_TYPE_NONE)
+ flow_type = IRQ_TYPE_LEVEL_LOW;
+
+ if (flow_type & (IRQ_TYPE_EDGE_RISING | IRQ_TYPE_LEVEL_HIGH))
+ goto err_sense;
}
desc->status &= ~(IRQ_TYPE_SENSE_MASK | IRQ_LEVEL);
@@ -181,6 +191,10 @@
if (vold != vnew)
out_be32(&cpm2_intctl->ic_siexr, vnew);
return 0;
+
+err_sense:
+ pr_err("CPM2 PIC: sense type 0x%x not supported\n", flow_type);
+ return -EINVAL;
}
static struct irq_chip cpm2_pic = {