pinctrl: clarify some dt pinconfig options
The bias-pull-* options use values > 0 to indicate that the pull should
be activated and optionally also indicate the strength of the pull.
Therefore use an default value of 1 for these options.
Split the low-power-mode option into low-power-enable and -disable.
Update the documentation to describe the param arguments better.
Reported-by: James Hogan <james.hogan@imgtec.com>
Signed-off-by: Heiko Stuebner <heiko@sntech.de>
Signed-off-by: Linus Walleij <linus.walleij@linaro.org>
Git-repo: git://git.kernel.org/pub/scm/linux/kernel/git/next/linux-next.git
Git-commit: 9ee1f7d266aa1e2bfeb20cb5d4ac299c
Change-Id: If16f7a091e4b1952b48c36de9bf3928b2455c24f
Signed-off-by: Hanumant Singh <hanumant@codeaurora.org>
diff --git a/drivers/pinctrl/pinconf-generic.c b/drivers/pinctrl/pinconf-generic.c
index 3f6884f..0781782 100644
--- a/drivers/pinctrl/pinconf-generic.c
+++ b/drivers/pinctrl/pinconf-generic.c
@@ -138,9 +138,9 @@
{ "bias-disable", PIN_CONFIG_BIAS_DISABLE, 0 },
{ "bias-high-impedance", PIN_CONFIG_BIAS_HIGH_IMPEDANCE, 0 },
{ "bias-bus-hold", PIN_CONFIG_BIAS_BUS_HOLD, 0 },
- { "bias-pull-up", PIN_CONFIG_BIAS_PULL_UP, 0 },
- { "bias-pull-down", PIN_CONFIG_BIAS_PULL_DOWN, 0 },
- { "bias-pull-pin-default", PIN_CONFIG_BIAS_PULL_PIN_DEFAULT, 0 },
+ { "bias-pull-up", PIN_CONFIG_BIAS_PULL_UP, 1 },
+ { "bias-pull-down", PIN_CONFIG_BIAS_PULL_DOWN, 1 },
+ { "bias-pull-pin-default", PIN_CONFIG_BIAS_PULL_PIN_DEFAULT, 1 },
{ "drive-push-pull", PIN_CONFIG_DRIVE_PUSH_PULL, 0 },
{ "drive-open-drain", PIN_CONFIG_DRIVE_OPEN_DRAIN, 0 },
{ "drive-open-source", PIN_CONFIG_DRIVE_OPEN_SOURCE, 0 },
@@ -151,7 +151,8 @@
{ "input-debounce", PIN_CONFIG_INPUT_DEBOUNCE, 0 },
{ "power-source", PIN_CONFIG_POWER_SOURCE, 0 },
{ "slew-rate", PIN_CONFIG_SLEW_RATE, 0 },
- { "low-power-mode", PIN_CONFIG_LOW_POWER_MODE, 0 },
+ { "low-power-enable", PIN_CONFIG_LOW_POWER_MODE, 1 },
+ { "low-power-disable", PIN_CONFIG_LOW_POWER_MODE, 0 },
{ "output-low", PIN_CONFIG_OUTPUT, 0, },
{ "output-high", PIN_CONFIG_OUTPUT, 1, },
};