sh: allow platforms to specify SD-card supported voltages
Boards can have different supplied voltages on different SD card slots. This
information has to be passed down to the SD/MMC driver.
Signed-off-by: Guennadi Liakhovetski <g.liakhovetski@gmx.de>
Acked-by: Ian Molton <ian@mnementh.co.uk>
Signed-off-by: Paul Mundt <lethal@linux-sh.org>
diff --git a/drivers/mfd/sh_mobile_sdhi.c b/drivers/mfd/sh_mobile_sdhi.c
index 19e0d48..cd16459 100644
--- a/drivers/mfd/sh_mobile_sdhi.c
+++ b/drivers/mfd/sh_mobile_sdhi.c
@@ -107,8 +107,10 @@
mmc_data->hclk = clk_get_rate(priv->clk);
mmc_data->set_pwr = sh_mobile_sdhi_set_pwr;
mmc_data->capabilities = MMC_CAP_MMC_HIGHSPEED;
- if (p)
+ if (p) {
mmc_data->flags = p->tmio_flags;
+ mmc_data->ocr_mask = p->tmio_ocr_mask;
+ }
if (p && p->dma_slave_tx >= 0 && p->dma_slave_rx >= 0) {
priv->param_tx.slave_id = p->dma_slave_tx;