arm: omap2plus: GPIO cleanup
use gpio_request_<one|array>() instead of multiple gpiolib calls,
remove unneeded variables, etc.
Signed-off-by: Igor Grinberg <grinberg@compulab.co.il>
Signed-off-by: Tony Lindgren <tony@atomide.com>
diff --git a/arch/arm/mach-omap2/board-devkit8000.c b/arch/arm/mach-omap2/board-devkit8000.c
index 405542a..3bd344a 100644
--- a/arch/arm/mach-omap2/board-devkit8000.c
+++ b/arch/arm/mach-omap2/board-devkit8000.c
@@ -242,7 +242,7 @@
/* TWL4030_GPIO_MAX + 0 is "LCD_PWREN" (out, active high) */
devkit8000_lcd_device.reset_gpio = gpio + TWL4030_GPIO_MAX + 0;
ret = gpio_request_one(devkit8000_lcd_device.reset_gpio,
- GPIOF_DIR_OUT | GPIOF_INIT_LOW, "LCD_PWREN");
+ GPIOF_OUT_INIT_LOW, "LCD_PWREN");
if (ret < 0) {
devkit8000_lcd_device.reset_gpio = -EINVAL;
printk(KERN_ERR "Failed to request GPIO for LCD_PWRN\n");
@@ -251,7 +251,7 @@
/* gpio + 7 is "DVI_PD" (out, active low) */
devkit8000_dvi_device.reset_gpio = gpio + 7;
ret = gpio_request_one(devkit8000_dvi_device.reset_gpio,
- GPIOF_DIR_OUT | GPIOF_INIT_LOW, "DVI PowerDown");
+ GPIOF_OUT_INIT_LOW, "DVI PowerDown");
if (ret < 0) {
devkit8000_dvi_device.reset_gpio = -EINVAL;
printk(KERN_ERR "Failed to request GPIO for DVI PowerDown\n");
@@ -483,14 +483,14 @@
{
unsigned char *eth_addr = omap_dm9000_platdata.dev_addr;
struct omap_die_id odi;
+ int ret;
- if (gpio_request(OMAP_DM9000_GPIO_IRQ, "dm9000 irq") < 0) {
+ ret = gpio_request_one(OMAP_DM9000_GPIO_IRQ, GPIOF_IN, "dm9000 irq");
+ if (ret < 0) {
printk(KERN_ERR "Failed to request GPIO%d for dm9000 IRQ\n",
OMAP_DM9000_GPIO_IRQ);
return;
- }
-
- gpio_direction_input(OMAP_DM9000_GPIO_IRQ);
+ }
/* init the mac address using DIE id */
omap_get_die_id(&odi);