[PATCH] remove old scsi data direction macros
these have been wrappers for the generic dma direction bits since 2.5.x.
This patch converts the few remaining drivers and removes the macros.
Arjan noticed there's some hunk in here that shouldn't. Updated patch
below:
Signed-off-by: James Bottomley <James.Bottomley@SteelEye.com>
diff --git a/drivers/scsi/libata-scsi.c b/drivers/scsi/libata-scsi.c
index 4e5e54a..4c96df0 100644
--- a/drivers/scsi/libata-scsi.c
+++ b/drivers/scsi/libata-scsi.c
@@ -305,7 +305,7 @@
sb[0] = 0x70;
sb[2] = MEDIUM_ERROR;
sb[7] = 0x0A;
- if (cmd->sc_data_direction == SCSI_DATA_READ) {
+ if (cmd->sc_data_direction == DMA_FROM_DEVICE) {
sb[12] = 0x11; /* "unrecovered read error" */
sb[13] = 0x04;
} else {
@@ -671,8 +671,8 @@
return;
/* data is present; dma-map it */
- if (cmd->sc_data_direction == SCSI_DATA_READ ||
- cmd->sc_data_direction == SCSI_DATA_WRITE) {
+ if (cmd->sc_data_direction == DMA_FROM_DEVICE ||
+ cmd->sc_data_direction == DMA_TO_DEVICE) {
if (unlikely(cmd->request_bufflen < 1)) {
printk(KERN_WARNING "ata%u(%u): WARNING: zero len r/w req\n",
ap->id, dev->devno);
@@ -1304,7 +1304,7 @@
struct scsi_cmnd *cmd = qc->scsicmd;
struct ata_device *dev = qc->dev;
int using_pio = (dev->flags & ATA_DFLAG_PIO);
- int nodata = (cmd->sc_data_direction == SCSI_DATA_NONE);
+ int nodata = (cmd->sc_data_direction == DMA_NONE);
if (!using_pio)
/* Check whether ATAPI DMA is safe */
@@ -1316,7 +1316,7 @@
qc->complete_fn = atapi_qc_complete;
qc->tf.flags |= ATA_TFLAG_ISADDR | ATA_TFLAG_DEVICE;
- if (cmd->sc_data_direction == SCSI_DATA_WRITE) {
+ if (cmd->sc_data_direction == DMA_TO_DEVICE) {
qc->tf.flags |= ATA_TFLAG_WRITE;
DPRINTK("direction: write\n");
}
@@ -1340,7 +1340,7 @@
#ifdef ATAPI_ENABLE_DMADIR
/* some SATA bridges need us to indicate data xfer direction */
- if (cmd->sc_data_direction != SCSI_DATA_WRITE)
+ if (cmd->sc_data_direction != DMA_TO_DEVICE)
qc->tf.feature |= ATAPI_DMADIR;
#endif
}