m68knommu: use setup_irq() in ColdFire simple timer
Use setup_irq() instead of request_irq() to set up system timer
in ColdFire simple timer code. With the old m68knommu irq code this
was safe, but it is not now within the generic irq framework.
Signed-off-by: Greg Ungerer <gerg@uclinux.org>
Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>
diff --git a/arch/m68knommu/platform/5307/timers.c b/arch/m68knommu/platform/5307/timers.c
index fb66ead..64bd0ff 100644
--- a/arch/m68knommu/platform/5307/timers.c
+++ b/arch/m68knommu/platform/5307/timers.c
@@ -3,7 +3,7 @@
/*
* timers.c -- generic ColdFire hardware timer support.
*
- * Copyright (C) 1999-2006, Greg Ungerer (gerg@snapgear.com)
+ * Copyright (C) 1999-2007, Greg Ungerer (gerg@snapgear.com)
*/
/***************************************************************************/
@@ -13,8 +13,8 @@
#include <linux/param.h>
#include <linux/interrupt.h>
#include <linux/init.h>
+#include <linux/irq.h>
#include <asm/io.h>
-#include <asm/irq.h>
#include <asm/traps.h>
#include <asm/machdep.h>
#include <asm/coldfire.h>
@@ -62,17 +62,24 @@
/***************************************************************************/
+static struct irqaction coldfire_timer_irq = {
+ .name = "timer",
+ .flags = IRQF_DISABLED | IRQF_TIMER,
+};
+
static int ticks_per_intr;
void coldfire_timer_init(irq_handler_t handler)
{
+ coldfire_timer_irq.handler = handler;
+ setup_irq(mcf_timervector, &coldfire_timer_irq);
+
__raw_writew(MCFTIMER_TMR_DISABLE, TA(MCFTIMER_TMR));
ticks_per_intr = (MCF_BUSCLK / 16) / HZ;
__raw_writetrr(ticks_per_intr - 1, TA(MCFTIMER_TRR));
__raw_writew(MCFTIMER_TMR_ENORI | MCFTIMER_TMR_CLK16 |
MCFTIMER_TMR_RESTART | MCFTIMER_TMR_ENABLE, TA(MCFTIMER_TMR));
- request_irq(mcf_timervector, handler, IRQF_DISABLED, "timer", NULL);
mcf_settimericr(1, mcf_timerlevel);
#ifdef CONFIG_HIGHPROFILE