[TG3]: Fix 5761 PXEboot crash
When 5761 devices boot the machine using PXEboot, PXE leaves the device
active when it terminates. The tg3 driver has code to detect this
condition and resets the device during initialization. On 5761 devices,
device resets involve sending a driver state update message to the APE
on the 5761. However, during this initialization stage, communications
to the APE registers have not yet been set up. The driver then
dereferences a NULL pointer and crashes the machine. The fix is to move
the APE register access setup earlier in the initialization code to
cover this condition.
Signed-off-by: Matt Carlson <mcarlson@broadcom.com>
Signed-off-by: Michael Chan <mchan@broadcom.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/net/tg3.c b/drivers/net/tg3.c
index cad5199..ddeaa0c 100644
--- a/drivers/net/tg3.c
+++ b/drivers/net/tg3.c
@@ -12464,43 +12464,6 @@
goto err_out_iounmap;
}
- /*
- * Reset chip in case UNDI or EFI driver did not shutdown
- * DMA self test will enable WDMAC and we'll see (spurious)
- * pending DMA on the PCI bus at that point.
- */
- if ((tr32(HOSTCC_MODE) & HOSTCC_MODE_ENABLE) ||
- (tr32(WDMAC_MODE) & WDMAC_MODE_ENABLE)) {
- tw32(MEMARB_MODE, MEMARB_MODE_ENABLE);
- tg3_halt(tp, RESET_KIND_SHUTDOWN, 1);
- }
-
- err = tg3_test_dma(tp);
- if (err) {
- printk(KERN_ERR PFX "DMA engine test failed, aborting.\n");
- goto err_out_iounmap;
- }
-
- /* Tigon3 can do ipv4 only... and some chips have buggy
- * checksumming.
- */
- if ((tp->tg3_flags & TG3_FLAG_BROKEN_CHECKSUMS) == 0) {
- dev->features |= NETIF_F_IP_CSUM | NETIF_F_SG;
- if (GET_ASIC_REV(tp->pci_chip_rev_id) == ASIC_REV_5755 ||
- GET_ASIC_REV(tp->pci_chip_rev_id) == ASIC_REV_5787 ||
- GET_ASIC_REV(tp->pci_chip_rev_id) == ASIC_REV_5784 ||
- GET_ASIC_REV(tp->pci_chip_rev_id) == ASIC_REV_5761)
- dev->features |= NETIF_F_IPV6_CSUM;
-
- tp->tg3_flags |= TG3_FLAG_RX_CHECKSUMS;
- } else
- tp->tg3_flags &= ~TG3_FLAG_RX_CHECKSUMS;
-
- /* flow control autonegotiation is default behavior */
- tp->tg3_flags |= TG3_FLAG_PAUSE_AUTONEG;
-
- tg3_init_coal(tp);
-
if (tp->tg3_flags3 & TG3_FLG3_ENABLE_APE) {
if (!(pci_resource_flags(pdev, 2) & IORESOURCE_MEM)) {
printk(KERN_ERR PFX "Cannot find proper PCI device "
@@ -12523,6 +12486,43 @@
tg3_ape_lock_init(tp);
}
+ /*
+ * Reset chip in case UNDI or EFI driver did not shutdown
+ * DMA self test will enable WDMAC and we'll see (spurious)
+ * pending DMA on the PCI bus at that point.
+ */
+ if ((tr32(HOSTCC_MODE) & HOSTCC_MODE_ENABLE) ||
+ (tr32(WDMAC_MODE) & WDMAC_MODE_ENABLE)) {
+ tw32(MEMARB_MODE, MEMARB_MODE_ENABLE);
+ tg3_halt(tp, RESET_KIND_SHUTDOWN, 1);
+ }
+
+ err = tg3_test_dma(tp);
+ if (err) {
+ printk(KERN_ERR PFX "DMA engine test failed, aborting.\n");
+ goto err_out_apeunmap;
+ }
+
+ /* Tigon3 can do ipv4 only... and some chips have buggy
+ * checksumming.
+ */
+ if ((tp->tg3_flags & TG3_FLAG_BROKEN_CHECKSUMS) == 0) {
+ dev->features |= NETIF_F_IP_CSUM | NETIF_F_SG;
+ if (GET_ASIC_REV(tp->pci_chip_rev_id) == ASIC_REV_5755 ||
+ GET_ASIC_REV(tp->pci_chip_rev_id) == ASIC_REV_5787 ||
+ GET_ASIC_REV(tp->pci_chip_rev_id) == ASIC_REV_5784 ||
+ GET_ASIC_REV(tp->pci_chip_rev_id) == ASIC_REV_5761)
+ dev->features |= NETIF_F_IPV6_CSUM;
+
+ tp->tg3_flags |= TG3_FLAG_RX_CHECKSUMS;
+ } else
+ tp->tg3_flags &= ~TG3_FLAG_RX_CHECKSUMS;
+
+ /* flow control autonegotiation is default behavior */
+ tp->tg3_flags |= TG3_FLAG_PAUSE_AUTONEG;
+
+ tg3_init_coal(tp);
+
pci_set_drvdata(pdev, dev);
err = register_netdev(dev);